American Dryer Corp MD-170 manual Specifications / Component Identification

Page 10

SECTION II

SPECIFICATIONS / COMPONENT IDENTIFICATION

A. SPECIFICATIONS (GAS and STEAM)

Maximum Capacity (Dry Weight)		170 lbs.		77.1 kg

Basket Diameter		51-1/2"		130.8 cm

Basket Depth		42-1/2"		107.9 cm

Basket Motor		1 HP		.746 kw

Blower Motor		7-1/2 HP		5.6 kw

Door Opening (Diameter)		31-3/8"		79.7 cm

Basket Volume		51.2 cu. ft.		1.45 cu. m.

Dryers Per 20’/40’ Container			3/7

Dryers Per 45’ /48’ Truck			8/8

	Voltage Available	208-600v / 3ø / 3, 4w 50/60 Hz

	Heat Input	550,000 btu/hr		138,600 kcal/hr

Gas	Approx. Weight (Uncrated)	1,900 lbs.		861.3 kg

	Approx. Weight (Crated)	2,065 lbs.		936.1 kg
	Approx. Weight (Crated)	2,065 lbs.		936.1 kg

	Airflow	3,700 cfm		104.75 cmm

	Inlet Size	1-1/2"		3.81 cm

	Compressed Air Connection	1/8" F.P.T.		---

	Compressed Air Requirement	2.5 cfm @ 80 PSI		.007 cmm @ 552 kPa

	Voltage Available	208-600v / 3ø / 3, 4w 50/60 Hz

	Approx. Weight (Uncrated)	2,050 lbs.		929.3 kg

	Approx. Weight (Crated)	2,220 lbs.		1,006.3 kg
Steam
Steam	Inlet Size	1-1/2"		3.81 cm
	Heat Input		19 Bhp
	Steam Consumption	725 lbs/hr		329.1 kg/hr
	Airflow	4,400 cfm		124.56 cmm


	Return Size	1-1/2"		3.81 cm

	Compressed Air Connection	1/8" F.P.T		---

	Compressed Air Requirement	6 cfh @ 80 PSI		.017 cmm @ 552 kPa

Shaded areas are stated in metric equivalents

IMPORTANT: Gas dryers and steam dryers must be provided with a clean, dry, regulated 80 PSI ±10 PSI (552 kPa ± 0.69 kPa) air supply.

NOTE: The manufacturer reserves the right to make changes in specifications at any time, without notice or obligation.

6

Image 10

Contents MD-170 Installation/Operators Manual Maytag CoRetain This Manual In a Safe Place For Future Reference For Your Safety Page Table of Contents Section Procedure for Functional Check of Replacement Section Important InformationSafety Precautions What to do if YOU Smell GASGAS Supply or the Steam Supply Before ANY Covers or Specifications / Component Identification Specifications GAS and SteamSpecifications MDG-170 Gas MDS-170 Steam Component Identification Page Installation Procedures Location RequirementsUNPACKING/SETTING UP Round duct can now be connected to the dryer Dryer Enclosure Requirements Fresh AIR Supply Exhaust Requirements Create a Potential Fire HazardPage Page Page Page Page Electrical Information MDG-170 Gas MDS-170 Steam Page Page GAS Information Type of GAS Latest Edition Page Steam Information Steam Requirements High PressureSteam Damper System Diagram 621 kPaPage Switch Otherwise the Dryer will not Start Preparation for OPERATION/START-UPPreoperational Tests Natural Gas Inches W.C .5 millibars Shut Down Instructions Basket CoatingCompressed AIR Requirements 621 kPaService SERVICE/PARTS InformationParts Warranty Information Returning Warranty CardsCleaning Routine MaintenanceClean the lint drawer or screen every third or fourth load Createa Potentialfire Hazard Adjustments LubricationTroubleshooting Drive motor is not operating does not startBlower impellor/fan motor is not operating does not start Failed blower impellor/fan drive shaft bearingsFailed microprocessor controller computer Failed keyboard touchpad label assembly GAS Models Steam Models Dryer operates but is taking too long to dry Gas Models Condensation on main door glass Dryer or scraping noise at tumbler basket area AA. Excessive noise and/or vibrationFailed drive motor contactor relay Failed motor Failed blower impellor/fan drive shaft bearings Steam Models Gas Models Steam Models Condensation on main door glass Excessive noise and/or vibration Reversing Timer SPIN/DWELLADJUSTMENTS Timing LegendData Label Location / Information Data Label GAS Manifold Pressure for GAS DryersProcedure for Functional Check Replacement Components Microprocessor computer BoardModels manufactured with ADC module Part No Theory Of Operation P O R T a N T ADC P/N114501 02/16/00-25 2- 02/25/00-250