American Dryer Corp MDG-75 manual SERVICE/PARTS Information, Service, Parts

Page 37

SECTION IV

SERVICE/PARTS INFORMATION

A. SERVICE

1.Service must be performed by a qualified trained technician, service agency, or gas supplier. If service is required, contact the distributor from whom the MAYTAG equipment was purchased. If the distributor cannot be contacted or is unknown, contact the MAYTAG Customer Service Department for a distributor in your area.

NOTE: When contacting the MAYTAG Customer Service Department, be sure to give them the correct model and serial numbers so that your inquiry is handled in an expeditious

manner.

B. PARTS

1.Replacement parts should be purchased from the MAYTAG distributor from whom the MAYTAG equip- ment was purchased. If the distributor cannot be contacted or is unknown, contact the MAYTAG for distributor in your area.

NOTE: When ordering replacement parts from the MAYTAG dealer be sure to give them the correct model and serial numbers so that your parts order can be processed

in an expeditious manner.

33

Image 37
Contents MDG-75 Retain This Manual In a Safe Place For Future Reference For Your Safety Page Table of Contents Section Procedure for Functional Check of Replacement Important Information SectionWhat to do if YOU Smell GAS Safety PrecautionsPage Specifications SPECIFICATIONS/COMPONENT IdentificationSpecifications Component Identification Dryer Rear View Illus. No Location Requirements Installation ProceduresUNPACKING/SETTING UP Dryer Enclosure Requirements Fresh AIR Supply Exhaust Requirements Not be Reduced Anywhere Down Stream of the Dryer Page Page Electrical Information MDG-75 GAS Page 3+$6 ‘ /&75,&$/&211&7,216/$6 Page Page GAS Information 48, 3523$1 Page Page Preparation for OPERATION/START-UP Gas Dryers Preoperational TestsPage Preoperational Instructions Shut Down Instructions Service SERVICE/PARTS InformationParts Returning Warranty Cards Warranty InformationCleaning Routine MaintenanceDays Days After Installation and Every 6 Months Thereafter AdjustmentsProcedure for Functional Check Replacement Components Page Page 1* /*1’ Reversing Timer Spin and Dwell AdjustmentsData Label Technical InformationApplicable Approval Seals From the Machine Toallowaccess for CLEANING,ADJUSTING Troubleshooting70 3$ Microprocessor Computer Models Blower and Fan motor is not operating does not start Loose connection in main door switch circuit Page GAS Models Failed microprocessor controller computer Dryer operates but is taking too long to dry Page AA. Condensation on main door glass Timer Models Blower/Fan motor is not operating does not start Page Dryer operates but is taking too long to dry Page Condensation on main door glass Page 01/07/998-50