American Dryer Corp ML-96HS installation manual Service, Parts

Page 32

SECTION IV

SERVICE and PARTS INFORMATION

A. SERVICE

1.Service must be performed by a qualified trained technician, service agency, or gas supplier. If service is required, contact the distributor from whom the ADC equipment was purchased. If the distributor cannot be contacted or is unknown, contact the ADC Service Department for a distributor in your area.

NOTE: When contacting the ADC Service Department, be sure to give them the correct model number and serial number so that your inquiry is handled in an expeditious manner.

B. PARTS

1.Replacement parts should be purchased from the distributor from whom the ADC equipment was purchased. If the distributor cannot be contacted or is unknown, contact the ADC Parts Department for a distributor in your area. Parts may also be purchased directly from the factory by calling the ADC Parts Department at (508) 678-9000 or you may FAX in your order at (508) 678-9447.

NOTE: When ordering replacement parts from the ADC dealer or the ADC factory be sure to give them the correct model and serial numbers so that your parts order can be processed in an expeditious manner.

28

Image 32
Contents ML-96HS Retain This Manual In a Safe Place For Future Reference For Your Safety Page Table of Contents Section Important InformationSafety Precautions What to do if YOU Smell GASPage SPECIFICATIONS/COMPONENT Identification SpecificationsObligation Component Identification Dryer Rear View Installation Procedures Location RequirementsUNPACKING/SETTING UP Page Dryer Enclosure Requirements Fresh AIR Supply Exhaust Requirements Create a Potential Fire HazardSingle Dryer Venting Page Page Electrical Information G 9 6 H S Page GAS Information Type of GAS Piping and Connections Supply Voltage Must Match the Electric Service Exactly Preparation for Operation and START-UPPreoperational Tests Heat Circuit Operational TestOperating Instructions Shut Down Instructions Service PartsReturning Warranty Parts Warranty InformationReturning Warranty Cards Page Routine Maintenance CleaningAdjustments LubricationProcedure for Functional Check Replacement Components Hot Surface Ignition HSI System