American Dryer Corp ML-78II MLG-78II Gas, Electrical Service Specifications PER Dryer

2.Electrical Service Specifications

MLG-78II (Gas)

ELECTRICAL SERVICE SPECIFICATIONS (PER DRYER)

IMPORTANT: 208 VAC AND 240 VAC ARE NOT THE SAME. When ordering, specify exact voltage.

NOTES: A. When fuses are used they must be dual element, time delay, current limiting, class RK1 or RK5 ONLY. Calculate/determine correct fuse value, by applying either local and/or National Electrical Codes to listed appliance amp draw data.

B.Circuit breakers are thermal-magnetic (industrial) motor curve type ONLY. For others, calculate/ verify correct breaker size according to appliance amp draw rating and type of breaker used.

C.Circuit breakers for 3-phase (3Ø) dryers must be 3-pole type.

SERVICE		WIRE	APPROX.		MINIMUM	FUSING	CIRCUIT
	PHASE		AMP DRAW			Dual Element
VOLTAGE		SERVICE			WIRE SIZE		BREAKER
			60 Hz	50 Hz		Time Delay
120	1Ø	2	13	---	*	20	20
208	1Ø	2	7.6	---	*	12	15
208	3Ø	3/4	4.7	---	*	8	15
240	1Ø	2	7	---	*	10	15
240	3Ø	3	4.9	5.5	*	8	15
380-400	3Ø	3/4	---	3	*	5	15
416	3Ø	3/4	---	3.1	*	5	15
460/480	3Ø	3/4	2.8	---	*	5	15

* AWG Stranded Wire Type...size wire as per National Electrical Code or local codes.

IMPORTANT: The dryer must be connected to the electric supply shown on the data label that is affixed to the left side panel/wall area behind the control door. In the case of 208 VAC or 240 VAC, the supply voltage must match the electric service specifications of the data label exactly.

IMPORTANT: The wire size must be properly sized to handle the related current.

WARNING: 208 VAC AND 240 VAC ARE NOT THE SAME. Any damage done to dryer components due to improper voltage connections will automatically VOID THE WARRANTY.

NOTE: ADC reserves the right to make changes in specifications at any time without notice or obligation.

19