American Dryer Corp ML-78II Preoperational Instructions, Shut Down Instructions

Page 35

b.Dual Timer Models

1)Both dwell (stop) time and basket (tumbler) spin time are adjustable (refer to the illustration on page 37).

8.Check to insure that ALL setscrews (i.e., basket [tumbler] drive, idler, etc.) are tight.

J.PREOPERATIONAL INSTRUCTIONS

1.To start the dryer...

a.Microprocessor Controller (Computer) Dryers...

1)The light emitting diode (L.E.D.) display will read “REAdY.”

2)Press the “E” on the keyboard (touch pad).

3)The dryer will start and the display will flash “dRYING MANUAL CYCLE E” “dRY TEMP 180º F (82º C)” “COOL TEMP 80º F (27º C)” “30 REMAIN” “dRUM TEMP.”

Refer to the User’s Manual for detailed operating instructions.

b.Dual Timer Dryers...

1)Turn drying timer knob for a time of 20 minutes.

2)Select “High Temp.”

3)Push “Push To Start” switch.

4)To stop dryer, open the main door.

K.SHUT DOWN INSTRUCTIONS

If the dryer is to be shut down (taken out of service) for a period of time, the following must be performed:

1.Discontinue power to the dryer either at the external disconnect switch or the circuit breaker.

2.Discontinue the heat supply:

a. GAS MODELS...discontinue the gas supply.

1)SHUT OFF external gas supply shutoff valve.

31

Image 35
Contents ML-78II Retain This Manual In a Safe Place For Future Reference For Your Safety Page Table of Contents Section Routine Maintenance Receiving and Handling Important InformationWhat to do if YOU Smell GAS Safety PrecautionsPage Specifications SPECIFICATIONS/COMPONENT IdentificationSpecifications MLG-78II Gas Component Identification Page Location Requirements Installation ProceduresBefore Starting the Dryer UNPACKING/SETTING UPDryer Enclosure Requirements Fresh AIR Supply Requirements Horizontal Venting Exhaust RequirementsPage Page Page Electrical Requirements Electrical InformationMLG-78II Gas Electrical Service Specifications PER DryerPage Black Page Page GAS Information Type of GAS Page Page Preparation for OPERATION/START-UP Preoperational Tests Basket Coating Shut Down Instructions Preoperational InstructionsParts SERVICE/PARTS InformationService Returning Warranty Parts Warranty InformationReturning Warranty Cards WarrantyPage Suggested Cleaning Schedule Routine MaintenanceCleaning Lubrication AdjustmentsTiming Legend Reversing Timer SPIN/DWELL AdjustmentsData Label Data Label InformationSerial Number Procedure for Functional Check Replacement Components P O RTA N T