American Dryer Corp MLG31PCA installation manual Operating Instructions, Starting the Dryer

Page 34

SECTION IV

OPERATING INSTRUCTIONS

A. STARTING THE DRYER

1.Coin Dryers

The dryer is available for use when the light emitting diode (L.E.D.) display reads “FILL” and/or the amount needed to start the dryer (i.e., “25”). Once the load has been put into the dryer and the main door is closed, start the dryer as follows:

a.Insert the proper number of coins into the coin acceptor. Once the correct “Amount To Start” has been inserted, the L.E.D. display will read “PUSH” ... “tEnP.”

b.Determine fabric setting (selection). Setting “HI TEMP” is the high temperature range, “PERM PRESS” is the medium temperature range, and “LO TEMP” is the low temperature range.

Once the fabric temperature setting (selection) has been determined, you start the dryer by pressing the fabric setting key for the basket (tumbler) being used (i.e., “LO TEMP” setting for the upper basket [tumbler]).

c.The dryer will now start, and the L.E.D. display for the basket (tumbler) selected will read the setting and the time vended (i.e., “LO 10”).

d.The cycle time will count down until the drying and cooling cycles are completed.

e.Upon completion of the drying cycle and cooling cycle, the dryer will shut off, the tone (buzzer) will sound for 5-seconds, and the L.E.D. display will read “donE.”

NOTE: If theAnti-Wrinkle program is active, the L.E.D. display will remain reading “donE,” and the Dual Microprocessor Controller (DMC) computer will proceed through theAnti-Wrinkle program until the maximum “Active Guard Time” has expired or until the main door is opened, whichever comes first.

NOTE: If theAnti-Wrinkle program is not active or in use, the L.E.D. display will read “donE” until the main door is opened, at which time, the L.E.D. display will read “FILL” and/or the “Amount To Start.”

f.Notes

1)The dryer basket (tumbler) can be stopped at any time by opening the main door. To restart dryer, shut the main door and press desired setting.

NOTE: When a cycle is interrupted by opening the main door, cycle time will continue to count downward, regardless if the door is open or closed, until a keyboard (touch pad) selection is made.

30

Image 34
Contents MLG31PCA Retain This Manual In a Safe Place For Future Reference For Your Safety Page Table of Contents Section Procedure for Functional Check of Replacement Important Information Receiving and HandlingSafety Precautions What to do if YOU Smell GASPage Specifications 71-1/2Gas UNPACKING/SETTING UP Installation ProceduresLocation of the Dryer Page Dryer Enclosure Requirements Fresh AIR Supply Requirements Exhaust Requirements Page Page Page Page Page Page Electrical Information Electrical RequirementsLG31PCA GAS Information Type of GAS Typical GAS Connections Page Page Preparation for Operation Preoperational TestsPage Basket Tumbler Coating Shut Down Instructions Operating Instructions Starting the DryerPage Page Service SERVICE/PARTS InformationParts Returning Warranty Cards Warranty InformationWarranty Cleaning Routine MaintenanceSuggested Cleaning Schedule Adjustments LubricationTroubleshooting SectionviiiFailed motor contactor/relay DMC computer L.E.D. display reads dSFL Failed keyboard touch pad label assembly Failed DMC computer If the dryer is equipped with optional battery back-up Dryer operates, but is taking too long to dry Condensation on main door glass Procedure for Functional Check Replacement Components Page Optional Gas Piping Kit Part No 1 02/11/02-20 05/01/02-250