American Dryer Corp MLG31PCA manual

2)Selection (setting) changes can be made at any time during the drying cycle by opening and closing the main door and then making a new selection.

3)Additional time can be purchased at any time. If the dryer is in operation (drying mode) and additional coins are inserted, the light emitting diode (L.E.D.) display(s) will read “PUSH” ... “tEnP,” and the selection (setting) key for the appropriate basket (tumbler) must be pressed.

NOTE: Any one (1) of the three (3) selection keys can be pressed for the appropriate basket (tumbler). No matter which key is pressed, the Dual Microprocessor Controller (DMC) computer will continue the cycle selection time that was in operation at the time of inserting additional coins.

NOTE: When both baskets (tumblers) are in operation and additional coins are inserted for one (1) basket (tumbler) and the appropriate basket (tumbler) selection is made, the other basket (tumbler) automatically resumes cycle status.

2.Non-Coin (OPL) Dryers

The dryer is available for use when the L.E.D. display reads “FILL” and/or “FrEE.” Once the load has been put into the dryer and the main door is closed, start the dryer as follows:

a.Determine fabric setting (selection). Setting “HI TEMP” is the high temperature range, the “PERM PRESS” is the medium temperature range, and the “LO TEMP” setting is the low temperature range.

Once the fabric temperature setting (selection) has been determined, you start the dryer by pressing the fabric setting key for the basket (tumbler) being used (i.e., “LO TEMP” setting for the upper basket [tumbler]).

b.The dryer will now start, and the L.E.D. display for the basket (tumbler) selected will read the setting (selection) and the drying portion of the L.E.D. display will read “00” and count upwards in time.

c.Upon completion of the drying cycle and cooling cycle, the dryer will shut off, the tone (buzzer) will sound for 5-seconds, and the L.E.D. display will read “donE.”

NOTE: If theAnti-Wrinkle program is active, the L.E.D. display will remain reading “donE,” and the DMC computer will proceed through theAnti-Wrinkle program until the maximum “Active Guard Time” has expired or until the main door is opened, whichever comes first.

NOTE: If theAnti-Wrinkle program is not active or in use, the L.E.D. display will read “donE” until the main door is opened, at which time, the L.E.D. display will read “FILL” and/or “FrEE.”