b.Retaining Wheel(s) Replacement
1)Discontinue electrical power to the dryer.
2)Remove the four (4) Phillips pan head screws to remove the cover.
3)Remove the hardware (i.e., bolt, lock washer, and flat washer) from the hex nut and weld nut on the wheel mount.
4)Install the new retaining wheel.
Reinstall the lock washer then the flat washer onto the bolt and insert into lower mount hole through the retaining wheel and through the hex nut, then into the weld nut and snug up the bolt.
WARNING: ALL SERVICE and TROUBLESHOOTING SHOULD BE PERFORMED BYA QUALIFIED PROFESSIONAL or SERVICE AGENCY.
WARNING: WHILE MAKINGADJUSTMENTS, OBSERVE ALL SAFETY PRECAUTIONS DISPLAYED ON THE DRYER or SPECIFIED IN THIS MANUAL.
5) Reinstall cover and screws removed in Step #2.
6)Reestablish electrical power to the dryer.
c.Retaining Wheel(s) Adjustment
1) With the dryer operating, turn offset hex hub on retaining wheel until wheel is at proper tension.
2) Snug nut against offset hex hub and then tighten.
CAUTION: USE EXTREME CARE WHEN SETTING RETAINING WHEELTENSION. PERSONAL INJURY MAY RESULT.
NOTE: Proper retaining wheel tension has been achieved when the wheel spins and stops when slight pressure is applied (to the retaining wheel itself).
9 3