MOTOR SYNCHRONOUS AND VALVE REPLACEMENT(NON PUMP MODEL)
¡Lay the front of the floor.
¡Loosen two special screw and motor synchronous.
¡Take out the wire of motor synchonous from the bracket.
¡Separate the motor sycnchronous from the base.
¡Turn the valve by using screw driver as shown in picture.
BRAKE ADJUSTMENT
¡Loosen the adjustment bolt and turn the adjust- ment bolt until the end of the bolt touches to the brake lever.
¡Tighten the lock nut and apply a small amount of
Adjustment bolt |
|
Clutch lever | Brake lever |
|
Gear mechanism ass'y
¡Remove the valve lid from the valve drain assy.
NOTES:
1.The brake adjustment has been made at the factory, so that it is not
However, in case of insufficient brake operation, problem the upper procedure.
2.Overtightening of the adjustment bolt will cause poor brake performance.
3.Undertightening of the adjustment bolt will cause continuous braking and thereby. cause the problems of the motor during the spingcycle.
18DIRECTIONS