4. DIRECTIONS FOR INSTALLATION AND USE
§LOCATION OF WASHER
Check location where washer will be installed. Make sure you have everything necessary for correct installation. Proper installation is your responsibility.
•Do not place or store your washer below 0˚C(32˚F) to avoid any damage from freezing.
•Install the washer on the horizontal sold foor.
C
B
A 
UP 
DOWN
If the washer is installed on an unsuitable floor, it could make consider- able noise, vibrate and cause a malfunction.
If washer is not level, adjust the front leg(A) up or down for horizontal set- ting.
•Earthed electrical outlet(B) is required with 20cm of bottom back of washer cabinet.
•Hot and cold water faucets (C) must be within 1M of the upper back of the washer cabinet and provide water pressure 0.3kgf/cm2-
§DRAIN SYSTEM
Never forget to install drain hose before operating your washer. The packing box is opened, there are a drain hose.
• Conect the drain hose to the drain outlet at the back side of the washer.
Non-Pump Model
Pump Model
Drain hose
Drain Outlet
Drain hose 
NOTES
The opening must not be obstructed by carpeting when the washing machine is installed on a carpeted floor.
1In case that it goes over a door sill. Don’t let the height of the drain hose exceed 20cm from the bottom of washer.
2In case of extending the drain hose. Don’t let the total length exceed 3m.
3m
3Be careful that the end of the drain hose is not immersed in water.
20Cm
|
| Pump Model |
| |
Laundry tub drain system |
| Standpipe drain system | ||
• Top of tub must be at |
| • Needs a 3cm minimum diameter standpipe with minimum | ||
least 86cm (34inches) |
| carry away capacity of 30liters per minute. | ||
high and no higher than |
| • Top of tub must be at |
| |
130cm from bottom of | A | least 86cm(34inches) |
| |
washer (A) | high and no higher than | B | ||
| ||||
|
| 130cm from bottom of |
| |
|
| washer (B) |
| |
6DIRECTIONS