§HOW TO CONNECT THE INLET HOSE
Be careful not to mistake in supplying between the hot(maximum : 50˚C) and cold water.
In using only one water tap or in case of attached one water inlet valve, connect the inlet hose to the cold water inlet valve.
Do not over tighten : this could cause damage to couplings.
FOR ORDINARY TAP
1Pull down the collar of the inlet hose to separate it from the water tap adapter.
¡ collar
4Remove the tape, and screw connector B into connect A tightly.
Connector A
Connector B
2Loosen the four screws at the water tap adapter, but don’t loosen the screws until they are separated from the water tap adapter.
5Connect the inlet hose to the water tap adapter by pulling down the collar of the hose end.
3Connect the water tap adapter to the water tap and tighten the four screws evenly while pushing up the adapter so that the rubber packing can stick to the water tap tightly.
TAPE
6Connect the inlet hose adapter of the hose to the water inlet of the washer by turning it clock- wise to be fixed tightly.
•Please check the rubber packing inside the inlet hose adapter of the hose.
FOR |
|
| |
Connect the inlet | Connect the connec- | ||
1hose to the water tap | |||
by screwing the con- | necessary. |
| |
nector D tightly. |
|
|
|
|
| Connector |
|
|
| Inlet |
|
| Rubber |
|
|
Connector D | Packing |
| Rubber |
|
| Connector D | Packing |
|
|
| |
3Insert the inlet hose adapter into the water inlet of washer and turn it to be fixed.
Inlet Hose | Hose |
Connector C
• Assert the packing in the inlet
CONNECTION 7