Maytag MLG32PDA manual Adjustments, Lubrication

Page 34

B.ADJUSTMENTS

7 DAYS AFTER INSTALLATION and EVERY 6 MONTHS THEREAFTER

Inspect bolts, nuts, screws (bearing set screws), non-permanent gas connections (unions, shut-off valves, orifices, etc.), electrical terminations, and grounding connections.

Motor and drive belts should be examined. A cracked or seriously frayed belt(s) should be replaced. Tighten loose belt(s) when necessary and check the alignment.

Complete operational check of controls and valves.

Complete operational check ofALL safety devices (door switches, lint compartment switches, sail switches, burner and hi-limit thermostats).

C.LUBRICATION

The motor bearings, idler bearings, and tumbler bearings are permanently lubricated. NO LUBRICATION IS NECESSARY.

Page 33 Page 35
Image 34
Page 33 Page 35
Contents MLG32PDA What do YOU do if YOU Smell GASRetain This Manual In a Safe Place For Future Reference Page For Your Safety Table of Contents Routine Maintenance Section Important InformationSafety Precautions What to do if YOU Smell GASCan Create a Fire Hazard Specifications MLG32PDA Installation Procedures UNPACKING/SETTING UPLocation of the Dryer Dryer Enclosure Requirements Fresh AIR SupplyPage Exhaust Requirements Single Dryer VentingPage Page Page Electrical Information Page 120 GAS Information Type of GAS Page Preparation for Operation Preoperational TestsGas Inches Water Column Shut Down Instructions Operating Instructions Starting the DryerService SERVICE/PARTS InformationParts Returning Warranty Cards Warranty InformationWarranty Routine Maintenance CleaningDays Adjustments LubricationPart No 1 01/13/98-500 2* 05/06/98-500 05/19/98-500
Top Page Image Contents