3. Connect remaining wires
Connect the other wires to outer terminal block screws. Tighten screws. Replace the terminal block cover on the back of the dryer. Tighten strain relief nut. Now, go to “Venting Requirements.”
Use where local codes permit connecting
|
|
|
| ||
type |
|
|
|
|
|
|
|
|
Spade terminals with | Ring terminals |
upturned ends |
|
1. Remove center screw
B
Remove center terminal block screw (B).
2. Connect neutral wire
B
D
Connect neutral wire (white or center) (D) of power supply cord under center terminal block screw (B). Tighten screw.
3. Connect remaining wires
Connect remaining wires under outer terminal block screws. Tighten screws. Replace the terminal block cover on the back of dryer Tighten strain relief nut. Now, go to “Venting Requirements.”
15