Maytag W10096989B warranty Vacation, storage, and moving care, Moving Care, Reinstalling the Dryer

Page 11

Vacation, storage, and moving care

Non-Use or Storage Care

Operate your dryer only when you are at home. If you will be on vacation or not using your dryer for an extended period of time, you should:

1.Unplug dryer or disconnect power.

2.Clean lint screen. See “Cleaning the Lint Screen.”

Moving Care

For power supply cord-connected dryers:

1.Unplug the power supply cord.

2.Make sure leveling legs are secure in dryer base.

3.Use tape to secure dryer door.

For direct-wired dryers:

1.Disconnect power.

2.Disconnect wiring.

3.Make sure leveling legs are secure in dryer base.

4.Use tape to secure dryer door.

Reinstalling the Dryer

Follow the “Installation Instructions” to locate, level, and connect the dryer.

Changing the drum light (on some models)

1.Unplug dryer or disconnect power.

2.Open the dryer door. Locate the light bulb cover on the back wall of the dryer. Using a Phillips head screw driver, remove the screw located in the lower right-hand corner of the cover. Remove the cover.

3.Turn bulb counterclockwise. Replace the bulb with

a 10-watt appliance bulb only. Replace the cover and secure with the screw.

4.Plug in dryer or reconnect power.

Changing the Sensor Cycle Settings to Increase Drying Time

If all your loads on all Sensor cycles are consistently not as dry as you would like, you may change the default settings to increase the default dryness level.

Your sensor drying settings can be adjusted to adapt to different installations, environmental conditions or personal preference. This change is retained and will affect all of your Sensor cycles, not just the current cycle/load. There are

3 drying settings, which are displayed using the time display:

01Factory preset dryness level.

02Slightly drier clothes, 15% more drying time.

03Much drier clothes, 30% more drying time.

To change the drying settings:

NOTE: The settings cannot be changed while the dryer is running or paused. The dryer must be in standby mode (the power button is off) to adjust the default settings.

1.Before starting a cycle, press and hold the TEMP LEVEL button for 6 seconds.

2.Press the TEMP LEVEL button to select the dryness level shown in the time display: 01, 02, or 03.

3.Press START/PAUSE to save the new dryness level setting.

11

Image 11
Contents Guide D’UTILISATION ET Dryer Safety Page Use Sensor Cycles for better fabric care and energy savings Check Your Vent System for Good AIR FlowGood air flow Maintain good air flow byControl Panel & Features Options Items to dry Cycle Drying Default Available Cycle DetailsCycle Guide Sensor DRY Cycles Cycle Guide Timed DRY CyclesTemperature Tips Using Your DryerSetting the Drying Temperature Clean the lint screenTemp Level for use with Timed Cycles only Press POWER/CANCEL Setting modifiersWrinkle Prevent feature Select the desired cyclePress START/PAUSE to begin cycle Additional features on some modelsDryer Care Cleaning the dryer locationCleaning the dryer interior Cleaning the lint screenMoving Care Reinstalling the DryerTo change the drying settings Vacation, storage, and moving careIf you experience Possible Causes Solution TroubleshootingTroubleshooting This limited warranty does not cover Maytag Laundry WarrantySécurité DE LA Sécheuse Page Nettoyer le filtre à charpie avant chaque charge Circulation d’air adéquateTableau DE Commande ET Caractéristiques Par Disponibles Défaut Guide DE Programmes Programmes DE Séchage DE DétectionConseils de température Guide DE Programmes Programmes ManuelsRéglage de la température de séchage Durée par Options Détails du programmeSélectionner le programme désiré Utilisation DE LA SécheuseNettoyer le filtre à charpie Charger la sécheuseWrinkle Prevent Caractéristique Sélectionner les réglages de programmeRetirer la charpie accumulée Nettoyer l’emplacement de la sécheuseEntretien DE LA Sécheuse Nettoyage de l’intérieur de la sécheusePour modifier les réglages de séchage Réinstallation de la sécheusePrécautions à prendre avant un déménagement Changement de la lampe du tambour sur certain modèlesDépannage Dépannage La présente garantie limitée ne couvre pas Garantie DES Appareils DE Buanderie MaytagU.S.A. and Canada U.S.A