Maytag DV316LG manual Removal, Rear Bulk, Burner Re

Part Name	Descriptive Picture		How To Do
		13.Slide the Motor Blower.
			Assembly toward the heater and
			lift to disengage the tabs on the motor
			from the slots in the base.
		14.Remove the 14mm nut securing the blower
			wheel to the shaft. The nut is a left hand
Motor/Blow-			thread.
er		QRWH=#D#zuhqfk#fdq#eh#sodfhg#rq#erwk##
		#	# hqgv#ri#wkh#Prwru#Rxwsxw#Vkdiw1
Assembly
		15.Remove Blower Wheel.
Removal
		16.Remove the three screws
(2)			securing the blower housing to
			the motor bracket.
		17.Remove the three screws
			securing the blower housing to
			the motor bracket .
		18.Use a wide blade screwdriver to pop off the
			motor retentionclamps.
		1.Disconnect power supply to unit.
		2.Remove Top Cover.
		3.Remove Console.
Rear Bulk-		4.Remove Front Panel.
		5.Remove Console Back Cover.
head
		6.Remove Belt from Idler Pulley.
Removal		7.Remove Drum.
		8.Remove 7 screws from the back.
		9.Lift the rear bulkhead off the right
		and left side hangers.
		1.Disconnect power supply to unit.
		2.Shut off gas supply.
		3.Disconnect gas line.
		4.Remove two screws securing
		burner to bracket.
Burner Re-		QRWH=#Wkh#Ljqlwhu#Edu#lv#iudjloh1#Eh#
moval		# #	fduhixo#qrw#wr#gdpdjh#Ljqlwhu#zkhq##
		# #	uhprylqj#Exuqhu#Dvvhpeo1
		5.Remove the two screws attaching
		the housing to the burner bracket.
		The screws are recessed from view.
		6.Slide Burner Assembly from dryer.
		1.Disconnect power supply to unit.
		2.Remove Top Cover.
		3.Remove Console.
		4.Remove Front Cover.
Heater As-		5.Remove Heater Assembly retaining screw.
sembly		6.Slide Heater Assembly out the front of dryer.
Removal		7.Remove the wiring terminals from the Heater
		Assembly.
		8.Reinstall by aligning the tabs on the back
		bulkhead with the notches in the Heater As
		sembly.

####

5-5