Maytag DV316LG manual 14-8

29	DRUM	4E :front	Water level sensor	AS rerecomm	This may be	- Disconnect the water supply hose and check
	WASHER	loading	inferiority	ended	happened	whether there is a foreign material inserted in it.
	(MODEL	washing			when there	And then request an engineer’s inspection.
	NAME :	machine			is any foreign
	Q1*3*)	error			material inside
					the water
					supply and
					drain valve
					or the interior
					components of
					the prodcuts
					do not operate
					normally.
					- Water
					level sensor
					or mother
					rotation.
30	DRUM	5E :front	Water being not drained	AS rerecom-	It may be	Check the installation of drain hose and then
	WASHER	loading		mended	occurred when	if there is no trouble request an engineer’s
	(MODEL	washing			the drain hose	inspection.
	NAME :	machine			is go over the	Clean the filter of pump-drain motor. Guided by
	Q1*3*)	error			threshold or	instruction-manual.
					water is not
					drained.
					It may eb
					occurred when
					the The filter
					of pump-drain
					moder is fulled
					with dregs,
31	DRUM	OE :front	3E OVER-FLOW	General	It may be a	- After Draining the water power off and on and
	WASHER	loading		consulting	case that the	operate again. If it dose not work after so doing
	(MODEL	washing			supply water	request an engineer’s inspection.
	NAME :	machine			level is not
	Q1*3*)	error			detected.
32	DRUM	UE :front	4E UNBALANCE ERR	General	It may be hap-	Level the machine or arrange the entangled
	WASHER	loading		consulting	pened when	clothes. If it does not worked even after so doing
	(MODEL	washing			the floor of the	request an engineer’s inspection.
	NAME :	machine			installed palce
	Q1*3*)	error			is not flat or
					the clothes are
					entangled.
33	DRUM	HE1 : front	E5 WATER HEATER ERR	General	It may happen	Use the proper amount of detergent and power
	WASHER	loading		consulting	when the	off the machine till the temperaure is cooled
	(MODEL	washing			boiling tem-	down.
	NAME :	machine			peratuer rised	And if it does not work even after so doing
	Q1*3*)	error			rapidly. (It is	request an engineer’s inspection.
					also because
					too much
					detergent are
					used.)
34	DRUM	HE : front	E6 WATER HEATER ERR	AS rerecom-	It may appear	- In this case you are recommended our
	WASHER	loading		mended	when it dose	engineer’s inspection.
	(MODEL	washing			not reach to
	NAME :	machine			the set tem-
	Q1*3*)	error			perature within
					a certain time.
35	DRUM	1E :front	E7 Water level sensor	AS rerecom-	It may happen	- In this case you are recommended our
	WASHER	loading	ERR	mended	when there is	engineer’s inspection.
	(MODEL	washing			a trouble in air
	NAME :	machine			hose or water
	Q1*3*)	error			level sensor.
36	DRUM	cE : front	E8 Abnormal water tem-	AS rerecom-	Check	- Check whether the cold water is supplied
	WASHER	loading	perature ERR	mended	whether the	through the cold water supply hole and if
	(MODEL	washing			hose for hot	it doesn’t work after so doing request an
	NAME :	machine			and cold water	engineer’s inspection.
	Q1*3*)	error			is connected
					to the water
					supply hole.
37	DRUM	8E : front	E9 Water leakage ERR	AS rerecom-	Check	- In this case you are recommended our
	WASHER	loading		mended	whether there	engineer’s inspection.
	(MODEL	washing			is foreign ma-
	NAME :	machine			terial inserted
	Q1*3*)	error			in the drain
					filter.
38	DRUM	tE :front	E9 Water leakage ERR	AS rerecom-	Check	- In this case you are recommended our
	WASHER	loading		mended	whether there	engineer’s inspection.
	(MODEL	washing			is foreign ma-
	NAME :	machine			terial inserted
	Q1*3*)	error			in the drain
					filter.

14-8