Graco 308550ZAD important safety instructions Technical Data, 14-0.8 MPa, 1.4-8 bar

Page 34

Technical Data

 

Maximum fluid working pressure

. . . . . . . . . . . . . . . . . . . .

. . . . . . . . . . . . . . . . . . . . . . . 120 psi

 

 

(0.8 MPa, 8 bar)

Air pressure operating range

. . . . . . . . . . . . . . . . . . . .

. . . . . . . . . . . . . . . . . . . . 20–120 psi

 

 

(0.14–0.8 MPa, 1.4–8 bar)

Maximum air consumption

. . . . . . . . . . . . . . . . . . . .

. . . . . . . . . . . . . . . . . . . . . 175 scfm

Air consumption at 70 psi/60 gpm

. . . . . . . . . . . . . . . . . . . .

. . . . . . . . . . . . 60 scfm (see chart)

Maximum free-flow delivery

. . . . . . . . . . . . . . . . . . . .

. . . . . . . . . . . . 150 gpm (568 l/min)

Maximum pump speed

. . . . . . . . . . . . . . . . . . . .

. . . . . . . . . . . . . . . . . . . . . . 145 cpm

Gallons (Liters) per cycle

. . . . . . . . . . . . . . . . . . . .

. . . . . . . . . . . . . . . . . . . 1.03 (3.90)

Maximum suction lift

. . . . . . . . . . . . . . . . . . . .

. . . . . . . . 18 ft (5.48 m) wet or dry

Maximum size pumpable solids

. . . . . . . . . . . . . . . . . . . .

. . . . . . . . . . . . . . . 1/4 in. (6.3 mm)

* Maximum noise level at 100 psi and 50 cpm

. . . . . . . . . . . . . . . . . . . .

. . . . . . . . . . . . . . . . . . . . . . 90 dBa

* Sound power level

. . . . . . . . . . . . . . . . . . . .

. . . . . . . . . . . . . . . . . . . . . . 103 dBa

* Noise level at 70 psi and 50 cpm

. . . . . . . . . . . . . . . . . . . .

. . . . . . . . . . . . . . . . . . . . . . 85 dBa

Maximum operating temperature

. . . . . . . . . . . . . . . . . . . .

. . . . . . . . . . . . . . . 150_F (65.5_C)

Air inlet size

. . . . . . . . . . . . . . . . . . . .

. . . . . . . . . . . . . . . . . . . . . 1/2 npt(f)

Fluid inlet size

. . . . . . . . . . . . . . . . . . . .

. . . . . . . . . 2” Raised Face Flange

Fluid outlet size

. . . . . . . . . . . . . . . . . . . .

. . . . . . . . . 2” Raised Face Flange

Wetted parts

. . . . . . . . . . . . . . . . . . .

Vary by Model. See pages 27–29

Non-wetted external parts

aluminum, 302 and 316 stainless steel, polyester (labels)

Weight

 

 

Polypropylene pumps with Aluminum center section . . .

. . . . . . . . . . . . . . . . . . . .

. . . . . . . . . . . . . . . . . . 49 lb (22 kg)

PVDF pumps with Aluminum center section

. . . . . . . . . . . . . . . . . . . .

. . . . . . . . . . . . . . . . . . 68 lb (31 kg)

Polypropylene pumps with stainless steel center section

. . . . . . . . . . . . . . . . . . . 71 lb (32kg)

PVDF pumps with stainless steel center section

. . . . . . . . . . . . . . . . . . . .

. . . . . . . . . . . . . . . . . . 90 lb (41 kg)

Geolastr and Santoprener are registered trademarks of the Monsanto Co.

Loctiter is a registered trademark of the Loctite Corporation.

*Noise levels measured with the pump mounted on the floor, using Rubber Foot Kit 236452. Sound power measured per ISO Standard 9216.

34 308550

Page 33 Page 35
Image 34
Page 33 Page 35
Contents Instructions Parts List Important Safety InstructionsTable of Contents ModelsSymbols Equipment Misuse HazardToxic Fluid Hazard Tighten Screws Before First Use InstallationGeneral Information Toxic Fluid HazardGrounding Ground all of this equipmentTypical FLOOR-MOUNT Installation Air LineFluid Suction Line Installation of Remote Pilot Air LinesMountings Fluid Outlet LineFlange Connections Bolt Tightening SequenceChanging the Orientation of the Fluid Inlet and Outlet Ports Fluid Pressure Relief ValveFire and Explosion Hazard Air Exhaust VentilationVenting Exhaust AIR Operation Pressure Relief ProcedureStarting and Adjusting the Pump Flush the Pump Before First UseMaintenance Troubleshooting Problem Cause SolutionTroubleshooting Disassembly ServiceRepairing the Air Valve Tools RequiredReassembly Ball Check Valve Repair Relieve the pressure. Disconnect all hosesDiaphragm Repair Reassembly Standard Diaphragms Reassembly Overmolded Diaphragms 105 19 402 24 104 403 Bearing and Air Gasket Removal Detail of Air Valve Bearings Pump Matrix Husky 2150 Polypropylene and Pvdf Pumps, Series aRepair Kit Matrix For Husky 2150 Polypropylene and Pvdf Pumps, Series aAir Motor Parts List Matrix Column PartsFluid Section Parts List Matrix Column MufflerBall Parts List Matrix Column Seat Parts List Matrix ColumnDiaphragm Parts List Matrix Column 114 Torque Sequence Front View DimensionsSide View Pump Mounting Hole Pattern Dimension SST Center Aluminum Polypropylene Pvdf Cover Technical Data 14-0.8 MPa, 1.4-8 barPsi MPa, bar Performance ChartFeet meters Fluid Flow GPM lpmGraco Warranties Graco Information
Top Page Image Contents