Humminbird MATRIX 12, MATRIX 37 Nmea Output, Accessories Menu Tab, Advanced, with Temp/Speed Only

Page 27

www..reelschelSpeed Calibrationmatic..com

(Advanced, with Temp/Speed Only)

Speed Calibration will adjust the speed readout by the percentage entered, and will appear in the menu if a Temp/Speed Accessory is connected and the paddlewheel has moved at least once, when the unit is in Advanced User Mode (see Setup Menu Tab: User Mode.)

To change the Speed Calibration setting:

1.Make sure you are in Advanced User Mode, then highlight Speed Calibration on the Setup menu.

2.Use the LEFT or RIGHT 4-WAY Cursor Control keys to change the Speed Calibration setting. (-20% to +20%, Default = 0%)

NMEA Output

(Advanced)

NMEA Output turns the NMEA output on or off. This menu choice is available only when in Advanced User Mode (see Setup Menu Tab: User Mode.)

The following NMEA sentences are output:

DPT- Depth

MTW - Water Temperature

GLL - Lat/Lon Position

GGA - GPS Fix Data

RMC - Recommended Minimum Specific GNSS Data

VTG - Course Over Ground and Ground Speed

ZDA - Time and Date

When navigating, the following NMEA sentences are also output:

APB - Autopilot Sentence B

BWR - Bearing and Distance to Waypoint

RMB - Recommended Minimum Navigation Info

To turn NMEA Output on or off:

1.Make sure you are in Advanced User Mode, then highlight NMEA Output on the Setup menu.

2.Use the LEFT or RIGHT 4-WAY Cursor Control keys to change the NMEA Output to On or Off (On, Off, Default = Off).

Accessories Menu Tab

From any view, press the MENU key twice to access the tabbed Main Menu System, then press the RIGHT cursor key until the Accessories tab is selected.

If no accessories are attached to the Accessory Bus, no menu choices will appear under the Accessories tab. If an accessory is attached, however, additional menu choices that support the accessory will be added automatically. See the Operations Manual that comes with your accessory for detailed information.

Accessories Menu Tab

(no accessories attached)

Accessories Menu Tab

(with accessories attached)

NOTE: Accessories to enable WeatherSenseTM, GPS Functionality and the SmartCastTM Wireless Sonar Link require separate purchases. You can visit our website at www.humminbird.com or contact our Customer Resource Center at 1-334-687-0503 for additional details.

47

48

Page 26 Page 28
Image 27
Page 26 Page 28
Contents Operations Manual WwwThank You!..reelschel matic..com Table of ContentsSonar Menu Tab Alarms Menu TabSetup Menu Tab Accessories Menu Tab TroubleshootingSingle Beam Sonar DualBeam Plus SonarQuadraBeam Sonar Soft Bottom WwwWhat’s On..reelschelthe Disp ay matic..comBait Ball Hard BottomSonar View Understanding Sonar HistorySonar View Sonar Zoom View Full range viewSonar Zoom View Big Digits View Big Digits ViewDualBeam Plus and QuadraBeamTM Only 200/83 kHz Split Sonar ViewSide Beam View Bottom PresentationQuadraBeamTM Only Digital readouts in the Side Beam View cannot be customizedPOWER/LIGHT Key Key FunctionsView Key Exit Key WAY Cursor Control KeyAccessorymBusatic Powering Up the UnitMenu System Normal Operation Start-Up Options MenuSystem Status PC ConnectWith PC Connect Cable Only Upper Range To adjust the SensitivityTo adjust the Upper Range SensitivityTo adjust the Bottom View Chart SpeedTo adjust the Lower Range To adjust the Chart SpeedHighlight Zoom Level on the Sonar X-PressTMMenu To adjust the Zoom LevelSonar Menu Tab Sonar Zoom View OnlyTo turn Fish ID+ on or off Fish ID+TMTo use Beam Select Highlight Beam Select on the Sonar main menuReal Time Sonar RTS Window KHz SensitivityKHz Balance Advanced To change the Depth Lines settingTo change the Surface Clutter setting Surface ClutterMax Depth Water TypeTransducer Select Alarm Tone Depth AlarmFish ID Alarm Low Battery AlarmUnits Depth Units TempUnits Distance Language User ModeTriplog Reset Restore DefaultsAdvanced, Sonar View Only TemperatureSelect Readouts To Select ViewsTemp Offset To change the Depth Offset settingTo change the Temp Offset setting Depth OffsetAdvanced, with Temp/Speed Only Accessories Menu TabTo change the Speed Calibration setting Nmea OutputDisplay Problems Problem Possible CauseControl head loses power at high speeds Isolation Matrix Fishing System AccessoriesSpecifications Contact Humminbird
Related manuals
Manual 31 pages 15.56 Kb
Top Page Image Contents