Humminbird 363 manual 104

Page 111

Speed Over Ground (SOG): Speed Over Ground is the measurement of the boat’s progress across a given distance, and is the speed measurement provided by GPS. An alternate, Speed Through Water, is provided by a speed paddlewheel, and is the measurement of the flow past the boat, which may vary depending on current speed and direction. Speed Over Ground is optimal for navigation because accurate destination times can be derived from this measurement. Humminbird® products allow for input and display of both speed measurements.

Time To Go (TTG): Time To Go is the estimated time required to reach the destination waypoint. TTG is calculated using the SOG and DTG. See SOG and DTG.

Track: A Track is a series of saved points that define the past path of the boat. These Track Points are saved at regular time intervals. Tracks are a useful and quick method to see where you’ve been, and an easy guide to follow to get you back to the starting point. Generally, all GPS units have a limited number of Track Points that can be saved before the unit runs out of memory and begins erasing the first track points saved. Because of this, the user can adjust the Track Point Interval menu to increase the amount of time between when points are saved, and thus extend the distance covered by a track. Tracks can also be permanently saved to memory, and re-displayed at the user’s option.

Track Line (TRK): The Track Line is the desired line of travel between two waypoints, and represents the most efficient path between the two points because it is a straight line. The TRK is measured in degrees (i.e. 321°, where 000° is North, 090° East, 180° is South, 270° is West). See Cross Track Error and Course Over Ground.

Trackplotter: Trackplotter describes a navigation device that shows Present Position, along with Track, Waypoint, and Routes, but NO MAP in the background. See Chartplotter.

Trolling Grid: Trolling Grid is a Humminbird® feature that displays a precise reference grid around a waypoint. This grid is used as a guide pattern for trolling around a specific area to assure a more efficient and complete coverage of that area. Trolling Grid resolution be changed by zooming in or out on the chart. The Trolling Grid can also be rotated on the display to orient it for optimal boat course for wave and wind conditions.

UTC: UTC is an acronym for Universal Time Constant. UTC is the “standard time” used in navigation, and is the local time in Greenwich England. (UTC is equivalent to Greenwich Mean Time (GMT)). To display the correct Local Time in a Humminbird® GPS unit, the user must use the Local Time Zone menu and select the time zone (i.e. EST, CST).

WAAS: WAAS is an acronym for Wide Area Augmentation System. WAAS is

104

Page 110 Page 112
Image 111
Page 110 Page 112
Contents GPS Chartplotter Operations Manual Thank You Table of Contents Iii Key FunctionsSonar Menu Tab Chart Menu Tab Specifications Glossary How Sonar Works Peak to Peak measures power output at the highest points How GPS and Cartography Work DualBeam Plustm SonarPage Bait Ball Hard Bottom Rocky Bottom What’s On the DisplayAdjacent to your boat, including the following items 83 kHz, Wide Beam Hollow Fish SymbolSonar View Zoom View Chart ViewViews Sonar viewsSonar View Sonar ViewReal Time Sonar RTS Window Understanding Sonar HistoryBottom Presentation Freeze FramePage Sonar Zoom View Sonar Zoom View200/83 kHz Split Sonar View 200/83 kHz Split Sonar ViewBig Digits View Circular Flasher ViewBig Digits View Bird’s Eye View Bird’s Eye ViewChart View Chart View without Active CursorChart View with Active Cursor Combo View View OrientationCombo View Chart View with Cursor Present Viewing CartographyIntroduction to Navigation Waypoints, Routes and Tracks Waypoints, Routes and TracksSave, Edit, or Delete a Waypoint Navigate to a Waypoint or Position Add a Waypoint Target or Trolling Grid Navigation X-PressTMmenuSave, Edit or Delete a Route Edit, Delete or Hide Saved Tracks Save or Clear a Current TrackInfo Key POWER/LIGHT KeyKey Functions View KeyWAY Cursor Control Key Menu KeyExit Key Mark KeyGoto Key Zoom +/- KeyPress TM Menu Powering Up the UnitMenu System Title ScreenSonar Tab Normal Mode Advanced Mode Start-Up Options Menu Normal OperationNormal Simulator System Status Simulator System StatusSimulator System Status Self Test Screen Accessory TestSystem Status Accessory Test Screen Self TestGPS Diagnostic View GPS Diagnostic ViewSonar X-PressTMMenu Sonar views onlySonar X-PressTMMenu Sensitivity at Low Sensitivity at Medium To adjust the SensitivitySensitivity Highlight Sensitivity on the Sonar X-PressTMmenuUpper Range To adjust the Upper RangeTo adjust the Lower Range Lower RangeHighlight Lower Range on the Sonar X-PressTMmenu Bottom View Chart SpeedTo adjust the Chart Speed To adjust the Bottom ViewTo turn on Bottom Lock To adjust the Bottom RangeBottom Range Bottom LockOnly when Navigating Cancel NavigationTo Cancel Navigation Highlight Cancel Navigation on the Sonar X-PressTMmenuNavigation X-PressTMMenu Navigation views onlyNavigation X-PressTMMenu Waypoint Submenu contains the following menu choices Waypoint NameTo view the Waypoint Name Submenu Highlight WaypointName on the Navigation X-PressTMmenuCursor to Waypoint Save Current TrackClear Current Track To Skip Next Waypoint Save Current RouteSkip Next Waypoint To Save Current RouteOnly if a Target is Active Highlight Cancel Navigation on the Navigation X-PressTMmenuRemove Target To Remove a TargetTo Set the Size of the Sonar Window in the Combo View Remove GridSonar Window To Remove a GridWaypoint Name Submenu Most recently-created waypointSonar Menu Press the Menu key twice to access the Main MenuSonar Menu Tab Sonar tabBeam Select To use Beam SelectHighlight Beam Select on the Sonar main menu Fish ID+TM To turn Fish ID+TM on or offTransducer Cone and Fish Arches Highlight Fish ID Sensitivity on the Sonar main menu To change the Fish ID Sensitivity settingTo change the RTS Window setting Fish ID SensitivityHighlight Zoom Width on the Sonar main menu To change the Zoom Width SettingZoom Width KHz SensitivityTo change the Depth Lines setting Depth LinesDepth Lines To change the Surface Clutter setting Surface ClutterSurface Clutter Max Depth To change the Noise Filter settingTo change the Max Depth setting Noise FilterWater Type To change the Water Type settingNavigation Menu Tab Navigation tabNavigation Menu Tab Highlight Current Track on the Navigation main menu Current TrackCurrent Track allows you to view the Current Track submenu To view the Current Track SubmenuHighlight Saved Tracks on the Navigation main menu Saved TracksSaved Tracks allows you to view the Saved Tracks submenu To view the Saved Tracks SubmenuHighlight Waypoints on the Navigation main menu WaypointsWaypoints allows you to view the Waypoints submenu To view the Waypoints SubmenuRoutes Submenu contains the following menu choices RoutesTo view the Routes Submenu Highlight Routes on the Navigation main menuChart Orientation North ReferenceGrid Rotation Track Min Distance To change the Trackpoint Interval settingTo change the Track Minimum Distance setting Trackpoint IntervalMap Datum To change the Map Datum settingTo Delete All Navigation Data To change the Course Project Line settingCourse Projection Line Delete All Nav DataChart Menu Chart Menu TabMap Borders Chart Detail LevelTo change the Chart Detail Level setting Highlight Chart Detail Level on the Chart main menuSet Simulation Position To change the Map Borders settingTo change the Lat/Lon Grid setting Lat/Lon GridTo Clear Map Offset To change the Map Offset settingSet Map Offset Clear Map OffsetAlarms Menu Alarms Menu TabTo change the Fish ID Alarm setting Depth AlarmFish ID Alarm To change the Depth Alarm settingTo change the Temp Alarm setting Low Battery AlarmTemp Alarm To change the Low Battery Alarm settingTo change the Arrival Alarm setting Off Course AlarmArrival Alarm To change the Off Course Alarm settingTo change the Alarm Tone setting Drift AlarmAlarm Tone To change the Drift Alarm settingSetup Menu Tab Setup Menu TabUnits Depth Units TempUnits Distance User Mode Units SpeedLanguage To Restore Defaults Triplog ResetRestore Defaults To Reset TriplogSelect Readouts Default Sonar ViewSelect Readouts Advanced, Sonar view onlyTemp Offset To change the Depth Offset settingTo change the Temp Offset setting Depth OffsetTo change the Local Time Zone To change the Speed Calibration settingSpeed Calibration Local Time ZonePosition Format To change the Daylight Saving Time settingTo change the Position Format setting Daylight Saving TimeTo change the Date Format Time FormatDate Format To change the Time FormatTo turn Nmea Output on or off Nmea OutputTo turn Sonar on or off SonarTo Change the View Status of Any View Views Menu TabSeriesTM Defaults to Simulator with a Transducer Attached TroubleshootingDisplay Problems Problem Possible CauseOr faulty Cavitation from Finding the Cause of NoiseIsolation Boat’s engineSpecifications Sonar Terms GlossaryPage Image Update Page Page Receiver See Transmitter Page Page Page GPS & Navigation Terms 101 102 103 104 105 106 107 108 109 Contact Humminbird
Top Page Image Contents