SETTING AND CLEARING THE ALARM
Use alarm mode to turn on the 700 Series at a
When the alarm is activated, your 700 Series will play the last selected input source at the volume level in use when the unit was turned off.
Menu key
Encoder
To set the alarm:
1.Press the Menu key.
2.Turn and then press the Rotary Encoder to select Settings > Clock > Set alarm.
3.Do one or both of the following:
•Turn the Rotary Encoder to change the hour setting.
•Press the Rotary Encoder to move to the minutes field. Adjust the minutes setting as required.
•Press the Rotary Encoder to move to the AM/PM field (if enabled). Turn encoder to select AM or PM.
4.Press the Menu key to save the time settings and exit (the time out feature does not operate here).
5.Highlight the Alarm enabled checkbox and press the Encoder to enable it ( 
).
6.Press any key to exit
To clear the alarm:
1.Press the Menu key.
2.Turn and then press the Rotary Encoder to select Settings > Clock.
3.Highlight the Alarm enabled checkbox and press the Rotary Encoder to disable
it ( 
).
4.Press any key to exit
13