Dakota Digital MX-5 operation manual Display

Page 11

MX-5 Ultrasonic Thickness Gauge

The Display

The numeric portion of the display consists of 4 complete digits preceded by a leading "1", and is used to display numeric values, as well as occasional simple words, to indicate the status of various settings. When the MX-5is displaying thickness measurements, the display will hold the last value measured, until a new measurement is made. Additionally,

when the battery voltage is low, the entire display will begin to flash.

When this occurs, the batteries should be replaced.

These eight vertical bars form the Stability Indicator. When the MX-5is idle, only the left-most bar and the underline will be on. While the gauge is taking a measurement, six or seven of the bars should be on. If fewer than five bars are on, the MX-5is having difficulty achieving a stable measurement, and the thickness value displayed will most likely be erroneous.

7

Page 10 Page 12
Image 11
Page 10 Page 12
Contents P-114-0002 Page Disclaimer ContentsBlank Introduction Blank Keypad OperationDakota Ultrasonics MX-5 Ultrasonic Thickness Gauge Dakota Ultrasonics Display Dakota Ultrasonics Transducer Making Measurements MX-5 Ultrasonic Thickness Gauge Condition and Preparation of Surfaces Performing a Probe-Zero Probe ZeroCalibration Calibration to a known thickness Calibration to a known velocity Two Point Calibration Moving series of dashes instead of a thickness value. When Scan ModeUsing the Beeper Alarm ModeDifferential Mode RS232 Serial Port Connecting To a Computer Transducer Selection Dakota Ultrasonics MX-5 Ultrasonic Thickness Gauge Blank Appendix a Product Specifications PhysicalBlank Application Notes ∙ Measuring pipe and tubing Appendix B∙ Measuring laminated materials MX-5 Ultrasonic Thickness Gauge Blank Sound Velocities of some Common Materials Appendix CBlank ∙ Warranty Statement ∙ Warranty InformationSONOTECH, INC
Top Page Image Contents