Dakota Digital MX-5 operation manual Alarm Mode, Using the Beeper

Page 23

MX-5 Ultrasonic Thickness Gauge

Alarm Mode

The Alarm Mode feature of the MX-5 allows the user to set an audible and visual parameter when taking measurements. When the Alarm Mode is on, the green LED is illuminated. If a measurement falls below a nominal value, set by the user, the red LED will illuminate and the beeper will sound, if enabled. This improves the speed and efficiency of the inspection process by eliminating constant viewing of the actual reading displayed. The following pages outline how to enable and set up this feature:

Using the Beeper

1)While the unit is off, press and hold down the ALRM key.

2)Press ON/OFF key to power up the unit.

3)Release the ALRM key - BEEP ON or BEEP OFF will be displayed enabling or disabling the beeper.

4)Repeat steps 1 through 3 to toggle between BEEP ON or BEEP OFF.

19

Page 22 Page 24
Image 23
Page 22 Page 24
Contents P-114-0002 Page Disclaimer ContentsBlank Introduction Blank Keypad OperationDakota Ultrasonics MX-5 Ultrasonic Thickness Gauge Dakota Ultrasonics Display Dakota Ultrasonics Transducer Making Measurements MX-5 Ultrasonic Thickness Gauge Condition and Preparation of Surfaces Performing a Probe-Zero Probe ZeroCalibration Calibration to a known thickness Calibration to a known velocity Two Point Calibration Moving series of dashes instead of a thickness value. When Scan ModeUsing the Beeper Alarm ModeDifferential Mode RS232 Serial Port Connecting To a Computer Transducer Selection Dakota Ultrasonics MX-5 Ultrasonic Thickness Gauge Blank Appendix a Product Specifications PhysicalBlank Application Notes ∙ Measuring pipe and tubing Appendix B∙ Measuring laminated materials MX-5 Ultrasonic Thickness Gauge Blank Sound Velocities of some Common Materials Appendix CBlank ∙ Warranty Statement ∙ Warranty InformationSONOTECH, INC
Top Page Image Contents