Dakota Digital operation manual MX-5 Ultrasonic Thickness Gauge

Page 15

MX-5 Ultrasonic Thickness Gauge

If the Stability Indicator has fewer than five bars darkened, or the numbers on the display seem erratic, first check to make sure that there is an adequate film of couplant beneath the transducer, and that the transducer is seated flat against the material. If the condition persists, it may be necessary to select a different transducer (size or frequency) for the material being measured. See page 23 for information on transducer selection.

While the transducer is in contact with the material that is being measured, the MX-5will perform four measurements every second, updating its display as it does so. When the transducer is removed from the surface, the display will hold the last measurement made.

IMPORTANT

Occasionally, a small film of couplant will be drawn out between the transducer and the surface as the transducer is removed. When this happens, the MX-5may perform a measurement through this couplant film, resulting in a measurement that is larger or smaller than it should be. This phenomenon is obvious when one thickness value is observed while the transducer is in place, and another value is observed after the transducer is removed.

11

Page 14 Page 16
Image 15
Page 14 Page 16
Contents P-114-0002 Page Disclaimer ContentsBlank Introduction Blank Keypad OperationDakota Ultrasonics MX-5 Ultrasonic Thickness Gauge Dakota Ultrasonics Display Dakota Ultrasonics Transducer Making Measurements MX-5 Ultrasonic Thickness Gauge Condition and Preparation of Surfaces Performing a Probe-Zero Probe ZeroCalibration Calibration to a known thickness Calibration to a known velocity Two Point Calibration Moving series of dashes instead of a thickness value. When Scan ModeUsing the Beeper Alarm ModeDifferential Mode RS232 Serial Port Connecting To a Computer Transducer Selection Dakota Ultrasonics MX-5 Ultrasonic Thickness Gauge Blank Appendix a Product Specifications PhysicalBlank Application Notes ∙ Measuring pipe and tubing Appendix B∙ Measuring laminated materials MX-5 Ultrasonic Thickness Gauge Blank Sound Velocities of some Common Materials Appendix CBlank ∙ Warranty Statement ∙ Warranty InformationSONOTECH, INC
Top Page Image Contents