Teledyne NALL instruction manual Table of Contents

Table of Contents
1.0	GENERAL INFORMATION	5
1.1	FEATURES:	5
2.0	OPERATING PRINCIPLE	6
2.1	OPERATING PRINCIPLE	6
3.0	RECEIVING AND INSPECTION	7
3.1	INITIAL INSPECTION:	7
3.2	PACKING LIST:	7
3.3	DECIMAL POINT SETTING:	7
3.4	POWER SOURCE:	7
3.5	ELECTRICAL ZERO:	7
3.6	INDICATION OF FLOW:	7
4.0	INSTALLATION INSTRUCTIONS	8
4.1	TRANSDUCER	8
4.2	FILTERS:	9
4.3	CABLES	9
4.4	POWER SUPPLY:	9
5.0	USING THE FLOWMETER	11
5.1	WARM-UPTIME:	11
5.2	RESPONSE TIME:	11
5.3	MASS FLOW UNITS:	11
5.4	SPECIAL FACTORY CALIBRATIONS:	11
5.5	GAS CONVERSION FACTORS:	11
5.6	OUTPUT SIGNAL:	12
5.7	ACCURACY:	13
5.8	REPEATABILITY:	13
5.9	OVER-RANGE:	13
6.0	PRESSURE EFFECTS	14
6.1	STANDARD TRANSDUCERS:	14
6.2	LOW PRESSURE DROP TRANSDUCERS:	14
6.3	HIGH PRESSURE TRANSDUCERS (OPTIONAL):	14
7.0	TEMPERATURE EFFECTS	15
7.1	AMBIENT TEMPERATURES:	15
7.2	GAS TEMPERATURE	15
8.0	DIFFERENTIAL PRESSURE	16
8.1	TYPICAL PRESSURE DROPS	16
8.2	CHANGES IN DP WITH CHANGES IN LINE PRESSURE	16
8.3	DP INCREASE DUE TO FOULING OF THE TRANSDUCER:	17
9.0	CALIBRATION	18
9.1	CALIBRATION PROCEDURES	18
10.0	MAINTENANCE	20
10.1	TRANSDUCERS:	20
10.2	POWER SUPPLY:	20
11.0	ACCESSORIES	21
11.1	OPTIONS AND ACCESSORIES	21
11.2	DOUBLE POINT RELAY FLOWMETER/ALARM (DNALL-P):	21
11.3	TOTALIZERS (TNALL-P):	21
11.4	CHASSIS MODEL (NALL-C):	22
11.5	CURRENT CONVERTER (NALL-P/CC):	22
Manual 111-082010_Nall Mass Flowmeters		Page 3 of 23