Installation Guide | 5 |
10.Tighten the hose clamps around the bullhorn ram and the rudder sensor’s barrel.
11.Tighten the starboard bullhorn bolt to secure the
12.Fit and tighten the supplied nut and washer to secure the threaded rod end of the sensor’s shaft to the
Notes:
1.If there is restricted space below the ram, you can mount the sensor in front of the ram (not below it).
2.We recommend installing the sensor with its shaft pointing to starboard. If you cannot install the unit in this orientation, you can fit it with the shaft pointing to port. If you do this, swap the red and green connections at the course computer.
Connecting to the course computer
1.Route the cable to the autopilot or course computer, taking into account the EMC installation guidelines.
2.Connect to the RUDDER terminals on the autopilot or course computer, as described in the owner’s handbook. If required, fit the spade connectors provided.
Note: To allow for the bullhorn’s movement, leave a loop of cable at the end of the linear rudder position sensor. If the standard cable is not long enough, your Raymarine dealer can supply a 10 m (30 ft) extension cable (part number: D173).
Post installation checks
When you have connected the sensor to your autopilot, pressurize the steering system (if required).
Note: Contact your steering gear manufacture for advice on this step. Follow their instructions for
When you have done this, check the sensor’s operation as described in the autopilot owner’s handbook.