OPERATING INSTRUCTIONS FOR GAMBIT EQUALIZER | OPERATION |
|
|
Graph 8: Backup Display
Select “Create 
1” to save the current snapshots to bank 1. Select “Restore 
1” to overwrite the current snapshots with bank 1 (ditto for bank 2).
A backup will overwrite “safe” snapshots.
Reset
To reinstall the factory snapshots you must press the “menu” key then choose the “System” and then the “Reset all” option. This will reset the current snapshots. The snapshots that have been backed up are preserved.
Dumping
The settings of all 128 snapshots can be dumped to a remote control port to be stored externally. Please make sure that you have connected eve- rything correctly and that the proper remote control port is activated (see chapter Remote Control for setup).
When dumping to a
Certain sequencers are not capable of hand- ling the amount of data output by the EQ1 and might crash during or after the dump process.
Always save the sequencer settings before recording a dump!
To initiate a dump, press the “menu” key then choose the “System” and then the “Dump” op- tion. Start the recording process on the se- quencer, then press “Transmit”. This releases the dump to the sequencer.
Loading
To load a snapshot dump from sequencer, simply play the dump sequence. The EQ1 will automati- cally switch into receive mode and display statis- tics about the snapshots it’s receiving. If the transmission was OK and no errors occured, the program switches back to normal mode. Upon error, you have to manually switch back to nor- mal mode.
When playing back the dump sequence, al- ways use the same speed as when the se- quence was recorded.
Daniel Weiss Engineering Ltd., Florastr. 42, |
| Page 13 of 27 |
) +41 1 940 20 06 2 +41 1 940 22 14 | 8 http://www.weiss.ch | * weiss@weiss.ch |