OPERATING INSTRUCTIONS FOR GAMBIT EQUALIZER | OPERATION |
|
|
Snapshot Display
Bottom line in the status display. Refer to this for information on current workspace and snapshot. There are two workspaces (“A” and “B”) for quick comparison of two equalizer settings. A workspace can be stored to a snapshot for later use.
The number of the last recalled snapshot will be displayed. If you change any value after the recall, the “
” will change to “
” to symbolize that the workspace is not equal to the displayed snapshot anymore.
For snapshot handling see chapter Snapshots.
Dither Icon
The dither icon is situated right next to key D (see Graph 2). If dither is off, the icon contains the number “24“, the word length of the output signal in bits. Turning dither on will produce ar- rows above and below the new word length number (“16“ or “20“). Additionally, if auto- blacking is enabled, the bottom right corner of the icon is inverted.
For details on dither refer to chapter Dither.
Daniel Weiss Engineering Ltd., Florastr. 42, |
| Page 7 of 27 |
) +41 1 940 20 06 2 +41 1 940 22 14 | 8 http://www.weiss.ch | * weiss@weiss.ch |