OPERATING INSTRUCTIONS FOR GAMBIT EQUALIZER | OPERATION |
|
|
Remote Control
All band parameters as well as control settings can be set externally.
To see remote control status refer to the status display.
Protocol
To select a remote control protocol, press key C from the status display menu. Select either “RS 232”, “RS 422” or “MIDI”. This will determine which port at the rear of the EQ1 is active. The other inactive ports will be ignored.
Press the “menu” key to return to the status dis- play if you do not want to change remote on/ off status.
When selecting a port other than MIDI you have to specify the baud rate. Refer to the remote control software manual for correct settings. The set baud rate is displayed to ensure proper set- up.
Channel
To change the remote control channel number, press key C (adjacent to the remote control field). Use the “gain/ data” encoder to select a value between 1 and 16. Press the “menu” key to re- turn to the status display.
The EQ1 does not support
On/ Off
To enable or disable remote control, press key C (adjacent to the remote control field). Press it again to toggle the “ON/
While remote control is off, data will still be sent to the selected port. Also, the MIDI THRU output will always mirror the MIDI IN input data re- gardless of “ON/ OFF” or protocol status.
Software Information
Press the “menu” key, then select the “System
Self Test
Press the “menu” key, then select the “System
Daniel Weiss Engineering Ltd., Florastr. 42, |
| Page 15 of 27 |
) +41 1 940 20 06 2 +41 1 940 22 14 | 8 http://www.weiss.ch | * weiss@weiss.ch |