Kenwood TK-2202, TK-3202 instruction manual Preparation

Page 9

PREPARATION

CHARGING THE Ni-MH BATTERY PACK

The battery pack is not charged at the factory; charge it before use.

The initial charging of the battery pack after purchase or extended storage (greater than 2 months) will not bring the battery pack to its normal operating capacity. After repeating the charge/discharge cycle 2 or 3 times, the operating capacity will increase to normal.

Do not recharge the battery pack if it is already fully charged. Doing so may cause the life of the battery pack to shorten or the battery pack may be damaged.

After recharging the battery pack, disconnect it from the charger. Charging the battery pack for more than 5 days may reduce the battery pack life due to overcharging.

Note:

The ambient temperature should be between 32°F and 104°F (0°C and 40°C) while charging is in progress. Charging outside this range may not fully charge the battery.

Always switch OFF the transceiver equipped with a Ni-MH battery pack before charging. Using the transceiver while charging its battery pack will interfere with correct charging.

The battery pack life is over when its operating time decreases even though it is fully and correctly charged. Replace the battery pack.

3

Image 9
Contents TK-2202 Page Thank YOU One or more of the following statements may be applicable Precautions Contents Part Number Unpacking and Checking EquipmentAntenna K, M Antenna K2, M2 Preparation Page INSTALLING/ Removing the Battery Pack Installing the Antenna Installing the Cover Over the SPEAKER/ Microphone Jacks Getting Acquainted Antenna LED indicatorProgrammable Auxiliary Functions Basic Operations Advanced Operations MONITOR/ Squelch OFF Priority Scan Revert Channel Temporary DeleteScrambler Voice Operated Transmission VOX Page Background Operations LOW Battery Warning Stun Transmitting Receiving