ACR Electronics HRU-100, 9490, Y1-06-0209G manual Installing the HRU in a SeaShelter

SECTION 6 – INSTALLING THE HRU IN A SeaShelter™

BRACKET

The ACR SeaShelter™ is a discontinued product that looks like this:

Contents of the HydroFix™ HRU Kit that you will need:

HydroFix™ Replacement Hydrostatic Release Unit (E)

SeaShelter™ release rod (A)

Keyed bracket adapter (D)

Large cotter pin (H)

HRU expiration label (K)

Tools required: Flat-head screwdriver

Instructions:
1.) Remove		the	front	cover and
						Figure A
	carefully	release the EPIRB
	from the bracket. If the front
	cover of the SeaShelter™
	contains	a	metal	bushing
	where the HRU rod is secured
	close (see Figure A), use a
	flat-head screwdriver and pry
	the bushing out of the top case and discard. This bushing prevents
	the HRU rod from securing to the cotter pin.
2.)	Remove the old HRU unit and rod from the bracket by pressing the
	spring release back and sliding the old HRU up and out of the
	bracket.
3.)	Take SeaShelter™ release rod (A) and place it on top of the rod on
	the HRU aligning the two sets of holes on the base (see Figure B).
4.)	Place large cotter pin (H) inside the two holes, securing the two rods
	together.
Y1-06-0209G					11