StarTech.com NETRS2321P manual System IP, System Status

Page 11

System IP

On this page, you can adjust the NETRS2321P network configuration. If set to DHCP mode, all other settings will be ignored, and the IP address will be assigned by DHCP server after resetting the device.

Press “Update” to store the data. Reset the device to take effect.

System Status

On this page, you can display the system Kernel firmware version and MAC Address.

You can also adjust the device alias (Target Name) and Idle timeout settings. The Target Name field allows a Max of 12 characters, including “0-9”,”a-z”,”A-Z”,”_” (underscore),and “-” (dash).

NETRS2321P

Press “Update” to store the ‘Target Name’ data, and then, NETRS2321P will reset to take effect.

Instruction Manual

7

Image 11

Contents Port RS232 Serial over IP Ethernet Device Server FCC Compliance Statement Table of Contents Product Applications Rear View Product OverviewTop View Front ViewSystem Reset Load Default Settings / System Reset ButtonLED Indicators Load Default SettingsRS-232 DB9 Male Pin Assignment RJ45 Ethernet Pin AssignmentsWeb Browser Method InstallationPackaging Contents IntroductionBroadcast Search Web Console Operation AdministratorAuthentication System Status System IPWeb Load default settingFirmware update Telnet Server / Client TCP ModeReverse Telnet CLI ModeClient mode inactive timeout Server mode protect timeoutRemote Address UDP ModeMode Local PortStop Bit Baud rateCharacter Bits Parity TypeUart Fifo Overflow count Reset DeviceHardware Flow Control Uart Memory Overflow countVirtual COM Software Operation ConfigurationCOM Mapping Server/Client TCP Mode onlySeconds for reconnection interval Enable Control Connection TCP Server or Client OnlyIP Address Remote PortProduct Applications Parity SpecificationsLimitation of Liability Technical Support Warranty Information