StarTech.com NETRS2321P manual TCP Mode, Telnet Server / Client

Page 13

TCP Mode

NOTE: When TCP mode is set to Server or Client mode, the UDP mode will be disabled automatically. When UDP mode is enabled, the TCP mode will be disabled automatically.

Once you have completed making changes, press "Update" to store the data. Reset the device to take effect.

Telnet Server / Client

Set the device to be a Telnet Server. In server mode, the Telnet port listens and waits for a host or other client to make a connection. In this case the Ethernet connected device is the client.

Set the device to be a Telnet Client. In the case the Ethernet connected device is the Telnet server or other NETRS2321P in server mode.

Instruction Manual

9

Image 13
Contents Port RS232 Serial over IP Ethernet Device Server FCC Compliance Statement Table of Contents Product Applications Top View Product OverviewFront View Rear ViewLED Indicators Load Default Settings / System Reset ButtonLoad Default Settings System ResetRS-232 DB9 Male Pin Assignment RJ45 Ethernet Pin AssignmentsPackaging Contents InstallationIntroduction Web Browser MethodBroadcast Search Authentication AdministratorWeb Console Operation System Status System IPFirmware update Load default settingWeb Telnet Server / Client TCP ModeClient mode inactive timeout CLI ModeServer mode protect timeout Reverse TelnetMode UDP ModeLocal Port Remote AddressCharacter Bits Baud rateParity Type Stop BitHardware Flow Control Reset DeviceUart Memory Overflow count Uart Fifo Overflow countVirtual COM Software Operation ConfigurationCOM Mapping Server/Client TCP Mode onlyIP Address Enable Control Connection TCP Server or Client OnlyRemote Port Seconds for reconnection intervalProduct Applications Parity SpecificationsLimitation of Liability Technical Support Warranty Information