Load default setting
On this page, you can load and store the factory default settings into EEPROM. NOTE: Network settings and MAC address will not be changed.
Press “Load” to load default settings. Reset the device to take effect.
Firmware update
On this page, you can update the firmware via Ethernet.
WARNING! Pressing the ‘Load’ button will immediately erase the flash with no further warning
1.Pressing the “Load” button will erase flash.
2.Wait for erase process to complete.
3.There are two methods to do the Firmware Update action (TFTP or Web):
NOTE: Please avoid loss of network connection, power or other interruption during the firmware upgrade procedure
Web
a.Please type in or browse the target image file in the input field, and then press “update” button to continue.
TFTP
a.Use Windows Command Prompt window to run the tftp client program.
Syntax: tftp -i 10.1.1.1 put FILE_DIRECTORY\FILENAME.bin
b.The firmware update should take about 45 seconds to complete.
c.If the update process somehow goes wrong (like power failure), please connect to http://10.1.1.1 to try and restart the process (you may have to reset the device first)
Instruction Manual
8