StarTech.com NETRS2321P manual UDP Mode, Local Port, Remote Address

Page 15

UDP Mode

When UDP mode is enabled, TCP mode will be disabled automatically. In UDP mode, the Local Port will be assigned to this device. You can list the remote connection IP and Port for up to 10 remote devices.

Once you have completed making changes, press "Update" to store the data. Reset the device to take effect.

Mode

Listen: When in UDP Listen mode, it can only receive remote UDP data.

Normal: When in UDP Normal mode, it can both receive and send UDP data to remote units.

Local Port

Assign the UDP port that this unit listens on.

Remote Address

The remote address table allows users to set several remote site IP addresses and ports. When sending data, the device will send UDP data to the IP addresses in the table.

Instruction Manual

11

Image 15

Contents Port RS232 Serial over IP Ethernet Device Server FCC Compliance Statement Table of Contents Product Applications Rear View Product OverviewTop View Front ViewSystem Reset Load Default Settings / System Reset ButtonLED Indicators Load Default SettingsRS-232 DB9 Male Pin Assignment RJ45 Ethernet Pin AssignmentsWeb Browser Method InstallationPackaging Contents IntroductionBroadcast Search Administrator AuthenticationWeb Console Operation System Status System IPLoad default setting Firmware updateWeb Telnet Server / Client TCP ModeReverse Telnet CLI ModeClient mode inactive timeout Server mode protect timeoutRemote Address UDP ModeMode Local PortStop Bit Baud rateCharacter Bits Parity TypeUart Fifo Overflow count Reset DeviceHardware Flow Control Uart Memory Overflow countVirtual COM Software Operation ConfigurationCOM Mapping Server/Client TCP Mode onlySeconds for reconnection interval Enable Control Connection TCP Server or Client OnlyIP Address Remote PortProduct Applications Parity SpecificationsLimitation of Liability Technical Support Warranty Information