StarTech.com NETRS2321P manual COM Mapping, Server/Client TCP Mode only

Page 19

COM Mapping

To map a virtual COM port, select COM Mapping from the left pane of the VCOM application, then click Add

Click OK to create the COM Mapping

TCP/UDP

Depending on the protocol you are using, the options below will enable/disable automatically as applicable.

Server/Client (TCP Mode only)

Set the device to be a Telnet Server. In server mode, the Telnet port listens and waits for a host or other client to make a connection. In this case the Ethernet connected device is the client.

Instruction Manual

15

Image 19

Contents Port RS232 Serial over IP Ethernet Device Server FCC Compliance Statement Table of Contents Product Applications Rear View Product OverviewTop View Front ViewSystem Reset Load Default Settings / System Reset ButtonLED Indicators Load Default SettingsRS-232 DB9 Male Pin Assignment RJ45 Ethernet Pin AssignmentsWeb Browser Method InstallationPackaging Contents IntroductionBroadcast Search Authentication AdministratorWeb Console Operation System Status System IPFirmware update Load default settingWeb Telnet Server / Client TCP ModeReverse Telnet CLI ModeClient mode inactive timeout Server mode protect timeoutRemote Address UDP ModeMode Local PortStop Bit Baud rateCharacter Bits Parity TypeUart Fifo Overflow count Reset DeviceHardware Flow Control Uart Memory Overflow countVirtual COM Software Operation ConfigurationCOM Mapping Server/Client TCP Mode onlySeconds for reconnection interval Enable Control Connection TCP Server or Client OnlyIP Address Remote PortProduct Applications Parity SpecificationsLimitation of Liability Technical Support Warranty Information