Eagle Electronics ID 128 manual Hull

Page 13

Clean the chosen area of the hull before attaching the suction cup. Locate the transducer on the hull as shown below. Don't allow the bracket to go below the hull, as water pressure against it can cause the suction cup to come off at speed. Moisten the cup, then press it onto the hull as firmly as possible. Tie the nylon cord to the boat and route the transducer cable to the sonar unit. Plug the transducer connector into the Fish ID 128. Your portable sonar is now ready for use.

HULL

13

Image 13
Contents Fish ID Table of Contents Introduction SpecificationsInstallation Bracket Location General Permanent Mount Transducer InstallationTransducer Assembly and Mounting Ratchets Transom Side View Fish Arches Power Connections -PERMANENT Mount Units only Fish ID 128 Portable Assembly Installing the Batteries Portable Transducer Assembly Hull PWR/CLEAR Keyboard BasicsMenu FWD/MENU REV UP and Down ArrowsAutomatic MenusZoom RangeSensitivity Fish ID FeatureFishtrack Chart Stop Chart SpeedDisplay Mode CHT 2 Chart #2Shallow Alarm Alarms Fish AlarmFEET/METER LightsDisplay Contrast Simulator ASP Advanced Signal ProcessingBoats Direction of Travel ABC Fish ArchesWater Temperature and Thermoclines Unit won’t turn on TroubleshootingUnit freezes, locks up, or operates erratically Electrical Noise No fish arches when the Fish ID feature is offPage Eagle Electronics Full ONE-YEAR Warranty Page How to Obtain Service How to Obtain Service U.S.A. Only