Eagle Electronics ID 128 manual Installation Bracket

INSTALLATION - Bracket

You can install the unit on the top of a dash or from an overhead with the supplied bracket. It can also be installed in the dash with an optional IDA- 3 or IDA-4 mounting kit. If you use the supplied bracket, you may be interested in the optional GBSA-1 swivel bracket kit. This converts the gimbal bracket to a swivel mount which can be used on the dash or overhead mounting positions. Installation instructions for the in-dash and swivel mounting kits are supplied with the adapter kits.

Mount the unit in any convenient location, provided there is clearance when it’s tilted for the best viewing angle. Holes in the bracket’s base allow wood screw or through bolt mounting. It may be necessary to place a piece of plywood on the back side of thin panels to reinforce the panel. Make certain there is enough room behind the unit to attach the power and transducer cables.

Drill a hole in the dash for the power and transducer cables. The best location for this hole is immediately under the gimbal bracket. This way, the bracket covers the hole. The smallest hole the power/transducer cable connector can pass through is 5/8". Note: Install the transducer before wiring the power cable!.After installing the transducer and power cables, slide the bracket over the hole, then route the transducer and power cables out the slot in the back of the bracket. Finally, fasten the bracket to the dash.

FISH ID 128

GIMBAL BRACKET

RUBBER WASHER

PLASTIC WASHER

(PORTABLE UNITS ONLY)

GIMBAL KNOB

Attach the unit to the gimbal bracket using the supplied gimbal knobs and washers as shown above.

4