Eagle Electronics ID 128 manual Troubleshooting, Unit won’t turn on

Page 25

SURFACE LAYER

ABSORBS HEAT

FROM THE SUN

EPILIMNION

THERMOCLINE

MOST PRODUCTIVE

ZONE FOR FISHING

HYPOLIMNION

The sonar can detect this invisible layer in the water, but the sensitivity will probably have to be turned up to see it.

TROUBLESHOOTING

If your unit is not working, or if you need technical help, please use the following troubleshooting section before contacting the factory customer service department. It may save you the trouble of returning your unit.

Unit won’t turn on:

1.Check the power cable’s connection at the unit. Also check the wiring.

2.Make certain the power cable is wired properly. The red wire connects to the positive battery terminal, black to negative or ground.

3.Check the fuse.

4.Measure the battery voltage at the unit’s power connector. It should be at least 11 volts. If it isn’t, the wiring to the unit is defective, the battery terminals or wiring on the terminals are corroded, or the battery needs charging.

25

Image 25
Contents Fish ID Table of Contents Introduction SpecificationsInstallation Bracket Location General Permanent Mount Transducer InstallationTransducer Assembly and Mounting Ratchets Transom Side View Fish Arches Power Connections -PERMANENT Mount Units only Fish ID 128 Portable Assembly Installing the Batteries Portable Transducer Assembly Hull PWR/CLEAR Keyboard BasicsMenu FWD/MENU REV UP and Down ArrowsAutomatic MenusZoom RangeSensitivity Fish ID FeatureFishtrack Chart Stop Chart SpeedDisplay Mode CHT 2 Chart #2Shallow Alarm Alarms Fish AlarmFEET/METER LightsDisplay Contrast Simulator ASP Advanced Signal ProcessingBoats Direction of Travel ABC Fish ArchesWater Temperature and Thermoclines Unit won’t turn on TroubleshootingUnit freezes, locks up, or operates erratically Electrical Noise No fish arches when the Fish ID feature is offPage Eagle Electronics Full ONE-YEAR Warranty Page How to Obtain Service How to Obtain Service U.S.A. Only