Eagle Electronics ID 128 manual Ratchets

Page 7

RATCHETS

remove the transducer and ratchets from the bracket. Place the ratch- ets into the holes in the bracket with the letter “B” aligned with the dot stamped in the bracket. Reassemble the transducer and bracket and place them against the transom. Again, check to see if you can move the transducer so it’s parallel with the ground. If it does, then go to step

3. If it doesn’t, repeat step 2, but use a different letter until you can place the transducer on the transom correctly.

3.Once you determine the correct position for the ratchets, assemble the transducer as shown below. Don't tighten the lock nut at this time.

METAL

NUT WASHER

	RUBBER	METAL
	WASHERS	METAL
	WASHERS	WASHER
		WASHER
		BOLT

7

Image 7

Contents Fish ID Table of Contents Introduction SpecificationsInstallation Bracket Location General Permanent Mount Transducer InstallationTransducer Assembly and Mounting Ratchets Transom Side View Fish Arches Power Connections -PERMANENT Mount Units only Fish ID 128 Portable Assembly Installing the Batteries Portable Transducer Assembly Hull UP and Down Arrows Keyboard BasicsPWR/CLEAR Menu FWD/MENU REVAutomatic MenusZoom RangeSensitivity Fish ID FeatureFishtrack CHT 2 Chart #2 Chart SpeedChart Stop Display ModeShallow Alarm Alarms Fish AlarmFEET/METER LightsDisplay Contrast Simulator ASP Advanced Signal ProcessingBoats Direction of Travel ABC Fish ArchesWater Temperature and Thermoclines Unit won’t turn on TroubleshootingUnit freezes, locks up, or operates erratically Electrical Noise No fish arches when the Fish ID feature is offPage Eagle Electronics Full ONE-YEAR Warranty Page How to Obtain Service How to Obtain Service U.S.A. Only