Eagle Electronics 500CDF manual Transom

Page 23

Hold the transducer and bracket assembly against the transom. The transducer should be roughly parallel to the ground. The trans- ducer's centerline should be in line with the bottom of the hull. Don't let the bracket extend below the hull!

Mark the center of each slot for the mounting screw pilot holes. You will drill one hole in the center of each slot.

Drill the holes. For the one-piece bracket, use the #29 bit (for the #10 screws). For the two-piece bracket, use the #20 bit (for the #12 screws).

Transom

Transom

Position transducer mount on transom and mark mounting holes.

Side view shown at left and seen from above at right.

5. Attaching transducer to transom.

A. One-piece bracket: Remove the transducer from the bracket and re- assemble it with the cable passing through the bracket over the bolt as shown in the following figures.

For single-frequency Skimmer, route cable over bolt and through bracket. Side view shown at left and seen from above at right.

17

Image 23
Contents Installation and Operation Instructions Page Table of Contents ColorLine level To turn Auto Sensitivity back on Page How this manual can get you out on the water, fast Read Me FirstPage Figuration and installation, bottom composi How Sonar Works How to Use this Manual Typographical Conventions Page Preparations Transducer InstallationSingle-frequency transom installations Pad Deadrise less than Strakes Good and poor transducer locations Transom Page Dot Alignment letters Positions Transducer Ratchets Bolt Transom Bottom Hull Flat-bottom hull Deep-vee hull Internal tooth washer TMB-S bracket Bolt Nut Flat washer Transducer mounted on trolling motor, side view Partial fish arches Hulls With Flotation Materials Transducer location High speed Trolling speed Page Epoxy transducer to hull Speed/Temperature Sensors Optional Speed Sensor Installation Good location Power Connections Power connections for the sonar unit Page Front 72.9 173.9 23.4 157.9 Millimeter 56.9 Inch In-Dash Template Face Cover Page Keyboard Basic Sonar OperationPower/lights on and off Main Menu Pages Pages Menu, showing Sonar display options Page Page Sonar Page, showing full sonar chart mode Basic Sonar Quick Reference Sonar Operations Page Page Important Tip Page Page Page ASP Advanced Signal Processing Sonar Options & Other FeaturesAlarms To adjust and turn on the shallow alarm To turn off the alarm, press ALARM↓ to Deep Alarm Enabledentexit Backlight Level Calibrate Speed Chart Speed ColorLine Thin or no ColorLine Wider ColorLine Depth Cursor ContrastDepth Range Manual Depth Range AutomaticFasTrack Fish I.D. Fish Symbols & Depths FishTrack Frequency Change Transducer Frequency SeaFinder CDF only Symbols with FishTrack depthsSonar Features menu with a frequency of 200 kHz selected Overlay Data HyperScrollNoise Rejection Page To return to the previous page, press Exit Tip Ping Speed & HyperScrollPage Pop-up Help Reset Options Set Keel Offset Reset Water DistanceScreen Contrast and Backlight Level Press MENUMENU↓ to SET Keel Offsetent Sensitivity & Auto Sensitivity Page Software Version Information Set LanguageSonar Page & Sonar Chart Display Options Sonar Chart ModePage Page Customizing the Digital Data/Chart Screen Sonar Simulator Stop Chart Surface Clarity Press ↓ or ↑ to select clarity levelEXITEXIT Units of Measure TransparencyZoom & Zoom Bar VolumeZoom Pan Troubleshooting Page Page Page Supplemental Material FCC Compliance Page Index Page Page 102 103 How to Obtain Service… Accessory Ordering Information for all countries Visit our web site