Eagle Electronics 500CDF manual Front

Page 38

Front

Install the gimbal bracket. Orient the bracket so the arms slope toward

the front of your unit.

Drill a 1-inch (25.4 mm) hole in the dash for the power and transducer cables. The best location for this hole is immediately under the gimbal bracket location. This way, the bracket can be installed so that it covers the hole, holds the cables in position and results in a neat installation. Some customers, however, prefer to mount the bracket to the side of the cable hole — it's a matter of personal preference.

After drilling the hole, pass the transducer connector up through the hole from under the dash. Pass the power cable's bare-wire end down though the hole from the top.

If you wish, you can fill in the hole around the cables with a good ma- rine caulking compound. (Some marine dealers stock cable hole covers to conceal the opening.) No matter what type of installation you prefer, be sure to leave enough slack in the cables to allow tilting or swiveling the unit. If you choose to fill in the hole, be sure to position the cables against the rear edge of the hole as you apply the fill material.

32

Image 38
Contents Installation and Operation Instructions Page Table of Contents ColorLine level To turn Auto Sensitivity back on Page Read Me First How this manual can get you out on the water, fastPage Figuration and installation, bottom composi How Sonar Works How to Use this Manual Typographical Conventions Page Transducer Installation PreparationsSingle-frequency transom installations Pad Deadrise less than Strakes Good and poor transducer locations Transom Page Dot Alignment letters Positions Transducer Ratchets Bolt Transom Bottom Hull Flat-bottom hull Deep-vee hull Internal tooth washer TMB-S bracket Bolt Nut Flat washer Transducer mounted on trolling motor, side view Partial fish arches Hulls With Flotation Materials Transducer location High speed Trolling speed Page Epoxy transducer to hull Speed/Temperature Sensors Optional Speed Sensor Installation Good location Power Connections Power connections for the sonar unit Page Front 72.9 173.9 23.4 157.9 Millimeter 56.9 Inch In-Dash Template Face Cover Page Basic Sonar Operation KeyboardPower/lights on and off Main Menu Pages Pages Menu, showing Sonar display options Page Page Sonar Page, showing full sonar chart mode Basic Sonar Quick Reference Sonar Operations Page Page Important Tip Page Page Page Sonar Options & Other Features ASP Advanced Signal ProcessingAlarms To adjust and turn on the shallow alarm To turn off the alarm, press ALARM↓ to Deep Alarm Enabledentexit Backlight Level Calibrate Speed Chart Speed ColorLine Thin or no ColorLine Wider ColorLine Contrast Depth CursorDepth Range Automatic Depth Range ManualFasTrack Fish I.D. Fish Symbols & Depths FishTrack Symbols with FishTrack depths Frequency Change Transducer Frequency SeaFinder CDF onlySonar Features menu with a frequency of 200 kHz selected Overlay Data HyperScrollNoise Rejection Page To return to the previous page, press Exit Ping Speed & HyperScroll TipPage Pop-up Help Reset Options Set Keel Offset Reset Water DistanceScreen Contrast and Backlight Level Press MENUMENU↓ to SET Keel Offsetent Sensitivity & Auto Sensitivity Page Set Language Software Version InformationSonar Chart Mode Sonar Page & Sonar Chart Display OptionsPage Page Customizing the Digital Data/Chart Screen Sonar Simulator Stop Chart Surface Clarity Press ↓ or ↑ to select clarity levelEXITEXIT Transparency Units of MeasureVolume Zoom & Zoom BarZoom Pan Troubleshooting Page Page Page Supplemental Material FCC Compliance Page Index Page Page 102 103 How to Obtain Service… Accessory Ordering Information for all countries Visit our web site