Faria Instruments IS0250a owner manual Installation, Panel Mount

Page 34

Part VI: Installation / Wiring Diagrams

INSTALLATION

Your Faria Antares unit can be mounted to your instrument panel in 4 ways; Panel Mount, Flush Mount, Gauge Mount, and Gimble Mount

Panel Mount

Step 1: Cut a square hole with rounded corners to match the dimensions as indicated in the figure below.

Step 2: Insert the Antares unit from front of panel, placing the Panel Mount Gasket (GK0206) between the Antares and the panel.

Step 3: From back of panel, install back clamp. The four interior studs should line up with the four interior holes of the back clamp. Tighten the supplied nuts, washers, and lock washers to 7-10 inch pounds (slightly more than finger tight)

Step 4: Connect 9-pin (HN0604) and 20-pin (HN0605) wire harnesses to back of Antares unit. Proper connection requires the locking ring on each harness to be rotated about ¼ turn.

Step 5: Connect available inputs to corresponding wire harnesses. See pages 34-37 for detailed wiring information

31

Page 33 Page 35
Image 34
Page 33 Page 35
Contents IS0250a Page Part I Introduction Page Part I Introduction Image Button Functions System Setup Input SetupPage Tank Setup Depth Setup Screen Indicator Icons Gauge Screen 1 / Gauge Screen Quick View Screen Fuel Flow Manager Screen Depth / Temp Screen Tank Level Screen GPS Screen Radio Control Screen Main Menu Screen Lighting Fuel Manager Total Amount of Fuel = Fuel Added + Fuel RemainingSystem Setup Units Calibrate Speedometer Calibration Trim Calibration Self Test Master Reset Diagnostics Alarm Icons Page Engine Alarms List Installation Panel MountFlush Mount Gauge Mount Gimble Mount HN0604 HN0605 HN0604 HN0605 Part VII FAQ / Troubleshooting Page Faria Marine Instruments
Top Page Image Contents