Faria Instruments IS0250a owner manual Gimble Mount

Page 37

Gimble Mount

Step 1: Locate a flat surface on your boat’s console to install the Antares Gimble Mount Bracket.

Step 2: Using a 3/16” drill bit, drill two holes 2.7” inches apart as indicated in the figure below.

Step 3: Using the supplied mounting hardware, mount the Gimble bracket through the holes you just drilled

Step 4: Using the supplied fasteners, mount the Antares unit into the Gimble bracket.

Step 5: Connect 9-pin (HN0604) and 20-pin (HN0605) wire harnesses to back of Antares unit. Proper connection requires the locking ring on each harness to be rotated about ¼ turn.

Step 6: Connect available inputs to corresponding wire harnesses. See pages 34-37 for detailed wiring information

34

Page 36 Page 38
Image 37
Page 36 Page 38
Contents IS0250a Page Part I Introduction Page Part I Introduction Image Button Functions Input Setup System SetupPage Tank Setup Depth Setup Screen Indicator Icons Gauge Screen 1 / Gauge Screen Quick View Screen Fuel Flow Manager Screen Depth / Temp Screen Tank Level Screen GPS Screen Radio Control Screen Main Menu Screen Lighting Total Amount of Fuel = Fuel Added + Fuel Remaining Fuel ManagerSystem Setup Units Calibrate Speedometer Calibration Trim Calibration Self Test Master Reset Diagnostics Alarm Icons Page Engine Alarms List Panel Mount InstallationFlush Mount Gauge Mount Gimble Mount HN0604 HN0605 HN0604 HN0605 Part VII FAQ / Troubleshooting Page Faria Marine Instruments
Top Page Image Contents