Lowrance electronic X47EX manual Metal Nut washer Rubber, Washers, Bolt, Transom

Page 11

3.Assembling the transducer. Once you determine the correct position for the ratchets, assemble the transducer as shown in the

following figure. Don't tighten the lock nut at this time.

Metal

Nut washer

Rubber	Metal washer
washers	Metal washer
	Bolt

Assemble transducer and bracket.

4.Drilling mounting holes. Hold the transducer and bracket assembly against the transom. The transducer should be roughly parallel to the ground. The transducer's centerline should be in line with the bottom of the hull. Don't let the bracket extend below the hull!

Mark the center of each slot for the mounting screw pilot holes. You will drill one hole in the center of each slot.

Drill the holes using the #29 bit (for the #10 screws).

Transom

Transom

Position transducer mount on transom and mark mounting holes.

Side view shown at left and seen from above at right.

5.Attaching transducer to transom. Remove the transducer from the bracket and re-assemble it with the cable passing through the bracket over the bolt as shown in the following figures.

7

Image 11

Contents X47 and X47EX Page Table of Contents Display Contrast Introduction Installation Preparations Shoot-through hull installations Transom installationTrolling motor installations Good location Poor location Location Poor angle Transom Transducer centerline Hull bottom Transom Transducer Assembly and MountingRatchets DotTransom Metal Nut washer RubberWashers BoltFlat-bottom hull Deep-vee hull BottomHull Internal tooth washer TMB-S bracket Bolt Nut Flat washer Trolling Motor Bracket InstallationFull fish arch Proper transducer angle Transducer Orientation and Fish ArchesSHOOT-THRU-HULL Preparation Partial fish arches Transducer aimed Too far backEpoxy the transducer to a solid portion of the hull Spread epoxy here Sand this surface Transducer location High speed Trolling speedPower and Cable Connections For the X47EX For 146.5113.5 Millimeters Inches Cut along this line Top137.9 157.9 Millimeter Inch 56.9 173.972.9 Front 107.5 82.776.9 Millimeter Inch 70.3 For Depress ratchets to release Bracket frontCell battery Page Hull Transducer Tie Nylon Cord here SuctionCup Bolt Nut Washer Transducer CupKeyboard Basics OperationMenu MemoryMenus Digital depth Water Temp Full Chart Zoom Enlarged fish arches SensitivityBait school Fish Arches Grayline Thin or no Grayline Wider Grayline Fish arches Fish I.D. symbolsFish I.D. Fishtrack Fish I.D. symbols showing FishTrack depth indicator Chart Scroll SpeedAlarms Display Adjustments Backlights System Info Display ContrastDepth Units of Measure Simulator Troubleshooting Page Noise Page In-dash mounting template for Page Lowrance Electronics Full ONE-YEAR Warranty How to Obtain Service… Accessory Ordering Information for all countries Visit our web site