Lowrance electronic X47EX manual 146.5, Millimeters Inches, For

Page 19

146.5

[5.76]

Top

R 7.9 [0.31]

In-Dash

Template

113.5

[4.46]

Millimeters

[Inches]

ALWAYS VERIFY DIMENSIONS

In-dash mounting template for X47EX, showing dimensions. NOTE: The preceding figure is not printed to scale. A scaled template is available for free download from our web site, www.lowrance.com.

For the X47

The X47 can be mounted in-dash using the removable scaled template inside the back cover of this manual (page 43). The FM-6 mount kit includes the necessary materials, but the instructions only appear here in this manual.

Please read all the instructions before proceeding. NOTE: Recommended

tools for this job include: jig saw, drill, drill bit (for starting hole).

1.Select the desired mounting location. Make sure there is enough room behind the dash to attach the unit's cable. The case is approximately 1-3/4" (45 mm) behind the mounting surface. You also need to allow an additional 1" (25 mm) for the power/transducer cable and connector.

2.Cut or tear out the template in the back of this manual (page 43) and tape it to the dash. Begin the cutout by drilling a starter hole near the center of the template. Use a drill bit big enough for the jigsaw blade.

3.Slip your saw blade into the starter hole and then cut along the outside line. Be careful when working around the corners, because there is little room for error.

4.Remove the backing from one side of the double-sided mounting tape contained in the mounting kit. Apply it to the outer ledge on the back of your unit. Starting at the bottom center, work the tape around all four sides of the unit. Cut off any excess tape when finished.

5.Attach the power/transducer cable to the back of the unit.

15

Image 19
Contents X47 and X47EX Page Table of Contents Display Contrast Introduction Installation Preparations Trolling motor installations Transom installationShoot-through hull installations Good location Poor location Location Poor angle Transom Transducer centerline Hull bottom Transom Transducer Assembly and MountingRatchets DotTransom Metal Nut washer RubberWashers BoltHull BottomFlat-bottom hull Deep-vee hull Internal tooth washer TMB-S bracket Bolt Nut Flat washer Trolling Motor Bracket InstallationFull fish arch Proper transducer angle Transducer Orientation and Fish ArchesSHOOT-THRU-HULL Preparation Partial fish arches Transducer aimed Too far backEpoxy the transducer to a solid portion of the hull Spread epoxy here Sand this surface Transducer location High speed Trolling speedPower and Cable Connections For the X47EX 113.5 Millimeters Inches 146.5For Cut along this line Top72.9 173.9137.9 157.9 Millimeter Inch 56.9 76.9 Millimeter Inch 70.3 107.5 82.7Front For Depress ratchets to release Bracket frontCell battery Page Hull Transducer Tie Nylon Cord here SuctionCup Bolt Nut Washer Transducer CupKeyboard Basics OperationMenus MemoryMenu Digital depth Water Temp Full Chart Zoom Enlarged fish arches SensitivityBait school Fish Arches Grayline Fish I.D. Fish arches Fish I.D. symbolsThin or no Grayline Wider Grayline Fishtrack Fish I.D. symbols showing FishTrack depth indicator Chart Scroll SpeedAlarms Display Adjustments Backlights Depth Units of Measure Display ContrastSystem Info Simulator Troubleshooting Page Noise Page In-dash mounting template for Page Lowrance Electronics Full ONE-YEAR Warranty How to Obtain Service… Accessory Ordering Information for all countries Visit our web site