Lowrance electronic X47EX manual Top, Cut along this line

Page 20

6.Remove the backing from the exposed side of the tape. Carefully place the unit into the dash cutout. Press down firmly around the entire outer edge to make sure the unit is secured to the dash.

Top

ALWAYS VERIFY DIMENSIONS.

Cut along this line

In-dash mounting template for X47. NOTE: This figure is not printed to scale. See the back of this manual for a scaled template copy you can tear out and use. Manual is available on our web site.

Bracket Installation

Mount the unit in any convenient location, provided there is clearance when it’s tilted for the best viewing angle. You should also make sure there is enough room behind the unit to attach the power/transducer cable. (See the following drawings, which show the dimensions of a gimbal-mounted X47EX sonar unit and an X47.)

Holes in the bracket’s base allow wood screw or through-bolt mounting. You may need to place a piece of plywood on the back side of thin panels to reinforce the panel and secure the mounting hardware.

16

Image 20

Contents X47 and X47EX Page Table of Contents Display Contrast Introduction Installation Preparations Shoot-through hull installations Transom installationTrolling motor installations Good location Poor location Location Poor angle Transom Transducer Assembly and Mounting Transom Transducer centerline Hull bottomDot RatchetsMetal Nut washer Rubber WashersBolt TransomFlat-bottom hull Deep-vee hull BottomHull Trolling Motor Bracket Installation Internal tooth washer TMB-S bracket Bolt Nut Flat washerTransducer Orientation and Fish Arches SHOOT-THRU-HULL PreparationPartial fish arches Transducer aimed Too far back Full fish arch Proper transducer angleEpoxy the transducer to a solid portion of the hull Transducer location High speed Trolling speed Spread epoxy here Sand this surfacePower and Cable Connections For the X47EX For 146.5113.5 Millimeters Inches Top Cut along this line137.9 157.9 Millimeter Inch 56.9 173.972.9 Front 107.5 82.776.9 Millimeter Inch 70.3 For Bracket front Depress ratchets to releaseCell battery Page Tie Nylon Cord here Suction Cup Bolt Nut Washer TransducerCup Hull TransducerOperation Keyboard BasicsMenu MemoryMenus Digital depth Water Temp Full Chart Zoom Sensitivity Enlarged fish archesBait school Fish Arches Grayline Thin or no Grayline Wider Grayline Fish arches Fish I.D. symbolsFish I.D. Fishtrack Chart Scroll Speed Fish I.D. symbols showing FishTrack depth indicatorAlarms Display Adjustments Backlights System Info Display ContrastDepth Units of Measure Simulator Troubleshooting Page Noise Page In-dash mounting template for Page Lowrance Electronics Full ONE-YEAR Warranty How to Obtain Service… Accessory Ordering Information for all countries Visit our web site