Transom installation

2.Determine the approximate location for the transducer and its cable route.

3.Determine the location of your battery or other power connection, along with the power cable route.

4.Install the transducer and route the transducer cable to the sonar unit.

5.Install the power cable and route it to the sonar unit.

6.Mount the sonar unit.

Transducer Installation

These instructions will help you install your Skimmer transducer on a transom, on a trolling motor or inside a hull. Please read all instructions before proceeding with any installation.

Your Skimmer transducer typically comes packaged with a one-piece stainless steel bracket for mounting it to the transom of your boat. The optional trolling motor mount uses a one-piece plastic bracket with an adjustable strap. These are "kick-up" mounting brackets. They help prevent damage if the transducer strikes an object while the boat is moving. If the transducer does "kick-up," the bracket can easily be pushed back into place without tools.

Read these instructions carefully before attempting the installation. Determine which of the installation methods is right for your boat. Remember, the transducer installation is the most critical part of a sonar installation.

Recommended Tools and supplies

If you prefer the option of routing the cable through the transom, you will need a 5/8" drill bit. The following installation types also call for these recommended tools and required supplies (supplies are not included):

Tools include: two adjustable wrenches, drill, #29 (0.136") drill bit, flat-

head screwdriver. Supplies: high quality, marine grade above- or below- waterline caulking compound.

Trolling motor installations

Tools: two adjustable wrenches, flat-head screwdriver. Supplies: plastic cable ties.

Shoot-through hull installations

Tools: these will vary depending on your hull's composition. Consult your

boat dealer or manufacturer. Supplies: 100 grit sandpaper, good quality epoxy adhesive.