Lowrance electronic X47EX manual Cell battery

Page 25

has a storage compartment for the portable transducer. The PPP-12 can be used with eight AA alkaline batteries. The PPP-13 can be used with eight D alkaline batteries or an optional sealed, rechargeable battery.

To use a portable power pack, you simply install the batteries and then attach the sonar unit to the power pack's bracket. Plug in the power/transducer cable and you're ready to fish.

(The PPP-12 has a quick-release mounting bracket built into the case. The PPP-13 requires you to attach the gimbal bracket to the case and then attach the sonar unit to the bracket with the supplied washers and knobs.)

Installing the Batteries

Release the latch on the front of the battery case. Open the compartment and install either an optional rechargeable battery, eight D batteries or eight AA batteries into the adapter. For the longest life, we recommend you use alkaline batteries.

NOTE:

When the unit is not in use, we recommend you unplug the power connector to reduce the possibility of corrosion or battery drain. When you store the unit, always remove the batteries because dead batteries can leak and corrode the contacts.

After installing the batteries, close the case and plug the sonar unit's power cable into the socket on the battery case.

"D" cell battery

Install batteries in power case battery adapter. PPP-13 shown.

Turn the sonar unit on. If it doesn't work, make sure the battery terminals are making good contact against the battery contacts. Also

21

Image 25
Contents X47 and X47EX Page Table of Contents Display Contrast Introduction Installation Preparations Trolling motor installations Transom installationShoot-through hull installations Good location Poor location Location Poor angle Transom Transducer centerline Hull bottom Transom Transducer Assembly and MountingRatchets DotWashers Metal Nut washer RubberBolt TransomHull BottomFlat-bottom hull Deep-vee hull Internal tooth washer TMB-S bracket Bolt Nut Flat washer Trolling Motor Bracket InstallationSHOOT-THRU-HULL Preparation Transducer Orientation and Fish ArchesPartial fish arches Transducer aimed Too far back Full fish arch Proper transducer angleEpoxy the transducer to a solid portion of the hull Spread epoxy here Sand this surface Transducer location High speed Trolling speedPower and Cable Connections For the X47EX 113.5 Millimeters Inches 146.5For Cut along this line Top72.9 173.9137.9 157.9 Millimeter Inch 56.9 76.9 Millimeter Inch 70.3 107.5 82.7Front For Depress ratchets to release Bracket frontCell battery Page Cup Bolt Nut Washer Transducer Tie Nylon Cord here SuctionCup Hull TransducerKeyboard Basics OperationMenus MemoryMenu Digital depth Water Temp Full Chart Zoom Enlarged fish arches SensitivityBait school Fish Arches Grayline Fish I.D. Fish arches Fish I.D. symbolsThin or no Grayline Wider Grayline Fishtrack Fish I.D. symbols showing FishTrack depth indicator Chart Scroll SpeedAlarms Display Adjustments Backlights Depth Units of Measure Display ContrastSystem Info Simulator Troubleshooting Page Noise Page In-dash mounting template for Page Lowrance Electronics Full ONE-YEAR Warranty How to Obtain Service… Accessory Ordering Information for all countries Visit our web site