Lowrance electronic X47EX manual Display Adjustments Backlights

Page 40

bottom goes shallower than the alarm's setting. The deep alarm sounds a tone when the bottom goes deeper than its setting. Both alarms adjust the same way, although through different menus.

Shallow Alarm

To set the shallow alarm depth, press MENU DOWN repeatedly until SHALLOW ALARM appears.

Press UP ARROW to increase the shallow alarm's depth setting or press DOWN ARROW to decrease it. The number in the shallow alarm’s menu box shows the current shallow

alarm setting. When the number reaches the desired setting, press PWR to clear the menu. When the bottom depth goes shallower than the alarm’s setting, an alarm tone sounds and a message box appears on the screen.

Press PWR to silence the alarm. This turns the alarm sound off until the shallow alarm is triggered again.

To turn the alarm off, press MENU DOWN repeatedly until SHALLOW ALARM appears. Press DOWN ARROW until the words OFF FEET appear, then press PWR to clear the menu.

Deep Alarm

To set the deep alarm depth, press MENU DOWN repeatedly until DEEP ALARM appears.

Press UP ARROW to increase the deep alarm's depth setting or press DOWN ARROW to decrease it. The number in the deep alarm’s menu box shows the current deep alarm

setting. When the number reaches the desired setting, press PWR to clear the menu. When the bottom depth goes deeper than the alarm’s setting, an alarm tone sounds and a message box appears on the screen.

Press PWR to silence the alarm. This turns the alarm sound off until the deep alarm is triggered again.

To turn the alarm off, press MENU DOWN repeatedly until DEEP ALARM appears. Press DOWN ARROW until the words OFF FEET appear, then press PWR to clear the menu.

DISPLAY ADJUSTMENTS

BACKLIGHTS

The display is backlit for night use. To turn the backlight on or off, press MENU repeatedly until the BACK LIGHT menu appears. Press UP ARROW to turn the light on or the DOWN ARROW to turn it off.

36

Image 40
Contents X47 and X47EX Page Table of Contents Display Contrast Introduction Installation Preparations Trolling motor installations Transom installationShoot-through hull installations Good location Poor location Location Poor angle Transom Transducer Assembly and Mounting Transom Transducer centerline Hull bottomDot RatchetsMetal Nut washer Rubber WashersBolt TransomHull BottomFlat-bottom hull Deep-vee hull Trolling Motor Bracket Installation Internal tooth washer TMB-S bracket Bolt Nut Flat washerTransducer Orientation and Fish Arches SHOOT-THRU-HULL PreparationPartial fish arches Transducer aimed Too far back Full fish arch Proper transducer angleEpoxy the transducer to a solid portion of the hull Transducer location High speed Trolling speed Spread epoxy here Sand this surfacePower and Cable Connections For the X47EX 113.5 Millimeters Inches 146.5For Top Cut along this line72.9 173.9137.9 157.9 Millimeter Inch 56.9 76.9 Millimeter Inch 70.3 107.5 82.7Front For Bracket front Depress ratchets to releaseCell battery Page Tie Nylon Cord here Suction Cup Bolt Nut Washer TransducerCup Hull TransducerOperation Keyboard BasicsMenus MemoryMenu Digital depth Water Temp Full Chart Zoom Sensitivity Enlarged fish archesBait school Fish Arches Grayline Fish I.D. Fish arches Fish I.D. symbolsThin or no Grayline Wider Grayline Fishtrack Chart Scroll Speed Fish I.D. symbols showing FishTrack depth indicatorAlarms Display Adjustments Backlights Depth Units of Measure Display ContrastSystem Info Simulator Troubleshooting Page Noise Page In-dash mounting template for Page Lowrance Electronics Full ONE-YEAR Warranty How to Obtain Service… Accessory Ordering Information for all countries Visit our web site