3. Setup your Fish Finder
3.1FISH FINDER SETUP MENU
The Fish Finder Setup menu provides access to additional functions, setup and layout/data field options.
From the Fish Finder page, access this menu by pressing:
[MENU]
Fig. 3.1 - Fish Finder Setup menu
3.1.1Preset Mode
Allows applying the following Fish Finder operating mode presets Fish and Cruise. See the following table.
[MENU] + "PRESET MODE" + [ENTER]
Fish | : Gain Mode = Auto, Range Mode = Auto, Frequency = do not change, Shift = 0, STC = Short if |
| Freq=200kHz and Mid if Freq=50kHz, Scrolling Speed = 10, Fish Symbols = Echo, |
| Surface Noise Filter = Off. |
Cruise | : Gain Mode = Auto, Range Mode = Auto, Frequency = do not change, Shift = 0, STC = Short if |
| Freq=200kHz and Mid if Freq=50kHz, Scrolling Speed = 10, Fish Symbols = Echo, |
| Surface Noise Filter = 4.. |
3.1.2Gain Mode
Selects Auto or Manual.
[MENU] + "GAIN MODE" + [ENTER]
3.1.3Range Mode
Selects among Manual, Auto Range and Bottom Lock. When in Manual Range Mode it is possible to set Shift (the offset from the surface) (see Par. 3.1.6) and Depth (see Par. 3.1.5) on which the Fish Finder shall operate. When in Auto Range Mode the Fish Finder determines automatically the range as to keep the bottom visible in the lower left of the screen. In this mode, Shift is always set to
0.In Bottom Lock Mode the Fish Finder automatically tracks the range around the bottom specified by the Bottom Range value.
[MENU] + "RANGE MODE" + [ENTER]
3.1.4Bottom Range
Shows the max depth to reach. This option is available when Range Mode is
User Manual | 19 |